Linksys SPA941 Telephone User Manual


  Open as PDF
of 6
 
Linksys SPA941 (Business Phone)
Getting Started
When you receive your SPA941 it should contain the following items:
1. Linksys SPA941 IP Phone, Handset and Stand.
2. Power supply
3. Network cable
4. Quick start guide
5. Handset Cord
If you have purchased your SPA941 (Business Phone) from Fonebox, your hardware will be
pre-configured and ready to use! Please note that steps 1 – 4 only of ‘Setting up your
hardware’ apply to fonebox products. BYO Customers should proceed with the remaining
instructions of this guide.
Setting up your hardware
Step n Connect the power cable to your SPA941 (Business Phone)
Step o Connect the network cable from your SPA941 to your DHCP enabled
Modem/router
Step p Turn the power on
IMPORTANT: The remaining instructions within this document apply to BYO Device customers only.
Step q
When the SPA941 boots up, press the Setup button on the phone.
Step r Factory Reset - any pre-existing settings within your device will be lost!
Press 14 for Factory Reset, Confirm yes.
Step s Go to Network Settings and Write down the IP address
__________________________
Configuring the SPA941 via the Web Interface
Step t Open a web browser from your PC and type in the IP address recorded
previously.
http://<IP Address of SPA941> ( e.g.
http://192.168.1.10 )
The Linksys Phone Adapter Configuration screen will now be showing on your
screen.
Pa
g
e 2 of 6
 previous next