Filter
Top Products
ANSWERER STATUS MESSAGES
0-59 Total number of messages.
CL (blinking) The voice time/day stamp needs to be set.
_ _
Answerer off.
An (blinking) Currently answering a call.
F (blinking) Memory is full.
Six bars (blinking) Recording a memo or announcement.
LA (Line Access) External line remote answerer.
CHANGING THE SECURITY CODE
The default security code for accessing the answerer from another location is 1 2 3.
You must use the handset to change the security code. With the phone off, follow
these steps:
1. Press ans button (the antenna indicator comes on).
2. Press tone (*).
3. Enter 3 numbers to be used as the new security code.
4. Press tone (*) again.
HEADSET AND BELT CLIP OPERATION
CONNECTING AN
OPTIONAL HEADSET TO
THE
HANDSET
For hands free conversation, connect the
headset (optional) to the HEADSET jack as
shown. The handset receiver and microphone
are disabled when the headset is connected.
Adjust the headset to rest comfortably on top of
your head and over your ear. Move the
microphone to approximately 2 to 3 inches from
your mouth.
• Press the TALK button to answer or place a
call before using the headset.
CONNECTING THE BELT
CLIP
There are two slots, one on each side of the
handset.
• Attach the belt clip by inserting the sides of
the belt clip into the slots. Snap the ends of
the belt clip into place.
CHANGING THE BATTERY
Make sure the telephone is OFF before you replace battery.
1. Remove the battery compartment door.
2. Disconnect the cord attached to the battery pack
and remove the battery pack from the handset.
3. Insert the new battery pack and connect the cord into
the jack inside the handset.
4. Put the battery compartment door back on.
5. Place handset in the base to charge. Allow the
handset battery to properly charge (for 12 hours)
prior to first use or when you install a new battery
pack. If you do not properly charge the phone,
battery performance will be compromised.
CAUTION: To reduce the risk of fire or
personal injury, use only the battery listed in the
instruction book.
BATTERY SAFETY PRECAUTIONS
• Do not burn, disassemble, mutilate, or puncture. Like
other batteries of this type, toxic materials could be
released which can cause injury.
• Keep batteries out of the reach of children.
• Remove batteries if storing over 30 days.
GENERAL PRODUCT CARE
To keep your telephone working and looking good, follow these guidelines:
• Avoid putting the phone near heating appliances and devices that generate
electrical noise (for example, motors or fluorescent lamps).
• DO NOT expose to direct sunlight or moisture.
• Avoid dropping and rough treatment to the phone.
• Clean with a soft cloth.
• Never use a strong cleaning agent or abrasive powder because this will damage
the finish.
• Retain the original packaging in case you need to ship the phone at a later date.
H
ANDSET
S
OUND
S
IGNALS
Signal Meaning
Three long beeps or continuous beeps Page signal
A long warbling tone (with ringer on) Incoming call signal
One short beep every few seconds Battery low
CAUSES OF POOR RECEPTION
• Aluminum siding
• Foil backing on insulation
• Heating ducts and other metal construction that can shield radio signals.
• You’re too close to appliances such as microwaves, stoves,
computers, etc.
• Atmospheric conditions, such as strong storms
• Base is installed in the basement or lower floor of the house.
• Base is plugged into AC outlet with other electronic devices.
• Baby monitor is using the same frequency.
• Handset battery is low.
• You’re out of range of the base.
• Microwave oven is using the same frequency.
SERVICE
FCC requires this product be serviced only by the manufacturer or its authorized
service agents. In accordance with FCC requirements, changes or modifications not
expressly approved by ATLINKS USA, Inc. could void the user’s authority to operate this
product. For instructions on how to obtain service, refer to the warranty included in this
guide or call customer service at 1-800-448-0329.
Or refer inquiries to:
ATLINKS USA, Inc.
Manager, Consumer Relations
P O Box 1976
Indianapolis, IN 46206
Attach your sales receipt to the booklet for future reference or jot down the date this
product was purchased or received as a gift. This information will be valuable if service
should be required during the warranty period.
Purchase date ________________________________________________
Name of store ________________________________________________
A
NSWERING
M
ACHINE
O
PERATION
This section highlights the buttons and features on the answering machine.
MESSAGES INDICATOR
The messages indicator blinks to show you how many new messages you have. The
answer on/off button must be on in order for the messages indicator to work.
SCREENING CALLS FROM THE BASE
You may screen incoming calls by waiting for the caller to begin leaving a message (to
hear who it is), then pick up the handset, and press talk to talk to the caller. The
answering machine automatically stops recording when you activate the handset or
pick up an extension phone.
TIP: Make sure the volume on the base is set loud enough to hear your incoming calls.
MESSAGE PLAYBACK
The messages indicator lets you know when you have messages. To play messages,
press play/stop.
While a message is playing, you may do the following:
• Press play/stop to stop the message playback.
• Press and release rev to restart the current message; continue to press and release
rev to go to previous messages.
• Press and release skip to go to the next message.
• Press play/stop to stop message playback.
MEMORY FULL
When the internal memory is full, the system answers after 10 rings. You may erase
some messages so the answerer will record new messages.
ERASING MESSAGES
You may erase messages three ways: one message at a time using the erase button on
the base; all messages using the erase button on the base; or one message at a time
using the erase button (0) on the handset or a phone in another location.
• To erase a message, press play/stop on the base and press and release
erase
button on the base to erase the message that is playing.
• To erase all messages, press the
erase
button on the base when messages have
stopped playing.
• To erase a message from the handset:
1. Press answer button on the handset.
2. Press play/stop on the handset (the 2 button).
3. Press erase on the handset (the 0 button) to erase the
message that is playing.
NOTE: You may only erase messages that have been reviewed. Erased messages cannot
be restored. Also, be careful not to press erase button as the next unheard message is
playing because that message will also be erased.
LEAVING A MEMO
Use the Memo feature to leave a message.
1. Press and hold the memo button. (You must hold down the button until you finish
recording the message.)
2. Begin speaking after you hear the beep.
3. Release the memo button when you are finished.
REMOTE ACCESS
This section explains two types of remote access: using the handset to access the
answering machine and accessing the answering machine from another phone.
The handset contains integrated buttons that enable you to access the answering
machine with the handset.
You can also access your answering machine from any phone that is tone-dial
compatible by entering a 3-digit security code after you hear the outgoing
announcement. A voice menu system guides you through all of the steps.
USING THE HANDSET
To access the answering machine from the cordless handset, press the ans button.
After you access the answerer, use the marked handset keys just as if you were
pressing the corresponding buttons on the base (see "Answering Machine Operation"
for details on functions). The functions are listed on the handset above each number
key. For example, to play messages:
1. Press the ans button.
2. Press 2 (play/stop).
3. When you are finished listening to your messages, press ans button again.
ANSWERER INDICATOR
The antenna indicator comes on if the answerer is being accessed by the handset.
SCREENING CALLS FROM THE HANDSET
Use the handset to screen calls even when you can't hear the answering machine.
When the phone rings:
1. Press the ans button to access the answering machine.
2. Listen as the caller leaves a message.
3. Press the talk button to speak to the person or press ans button to stop
screening the call.
MEMORY FULL
When the unit’s internal memory is full, the system answers after 10 rings, beeps and
waits for the 3-digit security code. If you don't enter the security code within 10 seconds
after the unit beeps, the phone hangs up.
You must erase some of the messages in order for the system to record new incoming
messages.
NOTE: The unit also answers after the 10th ring if it is turned off. To access the answerer
from another location, enter your 3-digit security code after you hear the beep.
ACCESSING THE ANSWERER FROM ANOTHER
PHONE
You can access your answering machine from any touch-tone phone by entering your
3-digit security code after you hear the outgoing announcement.
1. Dial the phone number for the answering machine.
2. Enter the security code after you hear the tone.
3. Follow the voice menu instructions to use the answerer's remote functions.
The remote feature enables you to perform the following functions:
To Press this Button
Review message 1
Play back messages 2
Stop message playback 2
Erase message 0 (during message
playback)
Skip message 3
Turn off answerer 4
Review voice menu options 7
TIP: You can bypass the outgoing announcement by pressing any numbered key on the
keypad while the announcement is playing. Then, you can enter your security code to
access the answering machine.
NOTE: The 7-segment message indicator will display LA when answerer is accessed
from another phone.
LIMITED WARRANTY
What your warranty covers:
• Defects in materials or workmanship.
For how long after your purchase:
• One year, from date of purchase.
(The warranty period for rental units begins with the first rental or 45 days from date
of shipment to the rental firm, whichever comes first.)
What we will do:
• Provide you with a new or, at our option, a refurbished unit. The exchange unit is
under warranty for the remainder of the original product’s warranty period.
How you get service:
• Properly pack your unit. Include any cables, etc., which were originally provided
with the product. We recommend using the original carton and packing materials.
•”Proof of purchase in the form of a bill of sale or receipted invoice which is
evidence that the product is within the warranty period, must be presented to obtain
warranty service.” For rental firms, proof of first rental is also required. Also print
your name and address and a description of the defect. Send via standard UPS or its
equivalent to:
ATLINKS USA, Inc.
c/o Thomson multimedia Inc.
11721 B Alameda Ave.
Socorro, Texas 79927
• Pay any charges billed to you by the Exchange Center for service not covered by
the warranty.
• Insure your shipment for loss or damage. ATLINKS accepts no liability in case of
damage or loss.
• A new or refurbished unit will be shipped to you freight prepaid.
What your warranty
does not
cover:
• Customer instruction. (Your Owner’s Manual provides information regarding
operating instructions and user controls. Any additional information, should be
obtained from your dealer.)
• Installation and setup service adjustments.
• Batteries.
• Damage from misuse or neglect.
• Products which have been modified or incorporated into other products.
• Products purchased or serviced outside the USA.
• Acts of nature, such as but not limited to lightning damage.
Product Registration:
• Please complete and mail the Product Registration Card packed with your unit. It
will make it easier to contact you should it ever be necessary. The return of the card
is not required for warranty coverage.
Limitation of Warranty:
• THE WARRANTY STATED ABOVE IS THE ONLY WARRANTY APPLICABLE TO THIS
PRODUCT. ALL OTHER WARRANTIES, EXPRESS OR IMPLIED (INCLUDING ALL
IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE) ARE HEREBY DISCLAIMED. NO VERBAL OR WRITTEN INFORMATION
GIVEN BY ATLINKS USA, INC., ITS AGENTS, OR EMPLOYEES SHALL CREATE A
GUARANTY OR IN ANY WAY INCREASE THE SCOPE OF THIS WARRANTY.
• REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE
EXCLUSIVE REMEDY OF THE CONSUMER. ATLINKS USA, INC. SHALL NOT BE
LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE
USE OF THIS PRODUCT OR ARISING OUT OF ANY BREACH OF ANY EXPRESS OR
IMPLIED WARRANTY ON THIS PRODUCT. THIS DISCLAIMER OF WARRANTIES
AND LIMITED WARRANTY ARE GOVERNED BY THE LAWS OF THE STATE OF
INDIANA. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY
IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE ON THIS PRODUCT IS LIMITED TO THE APPLICABLE WARRANTY
PERIOD SET FORTH ABOVE.
How state law relates to this warranty:
• Some states do not allow the exclusion nor limitation of incidental or consequential
damages, or limitations on how long an implied warranty lasts so the above
limitations or exclusions may not apply to you.
• This warranty gives you specific legal rights, and you also may have other rights
that vary from state to state.
If you purchased your product outside the USA:
• This warranty does not apply. Contact your dealer for warranty information.
HEADSET
Headset
jack
Headset
plug
Slot for
belt clip
Slot for
belt clip
CUSTOMER: CUT ALONG DOTTED LINE.
✂
A
CCESSORY
O
RDER
F
ORM
Please make sure that this form has been filled out completely.
*Prices are subject to change without notice.
Total Merchandise.........................................$_______________
Sales Tax........................................................$_______________
We are required by law to collect the appropriate sales tax for each individual state,
county, and locality to which the merchandise is being sent.
Use VISA or Master Card or Discover preferably. Money order or check must be in U.S.
currency only. No COD or Cash. All accessories are subject to availability. Where
applicable, we will ship a superseding model.
Shipping/Handling....................................... $_______________
Total Amount Enclosed.................................$_______________
Mail order form and money order or check (in U.S. currency) made payable
to Thomson multimedia Inc. to:
Thomson multimedia Inc.
Mail Order Department
P.O. Box 8419
Ronks, PA 17573-8419
Name_______________________________________________________
Address_____________________________________ Apt.____________
City ________________________State________ ZIP_________________
Daytime Phone Number ( )_______________________________
$5.00
____________________________________________________________________
Authorized Signature
My card expires:
Copy the number above your name on
the Master Card.
For credit card purchases
Your complete charge card number, its expiration date and your signature
are necessary to process all charge card orders.
Copy your complete account number from your VISA card.
My card expires:
Copy your complete account number from your
Master Card or Discover.
To order, call 1-800-338-0376 (for accessories only) or complete this order form.
DESCRIPTION
MODEL NUMBER
PRICE*
QUANTITY
TOTAL
5-2522
$14.95
Replacement battery
AC power supply
$15.50
5-2521
BLACK
Belt clip
Headset
5-2425
5-2535
$36.35
$4.95