Filter
Top Products
INSTALLATION INSTRUCTIONS
INSTALLATION
TELEPHONE BASE
HANDSET
STRAIGHT TELEPHONE CORD
To Telephone Jack
COILED HANDSET CORD
1. Insert the modular plugs of the COILED HANDSET CORD into the jack of the
TELEPHONE HANDSET and into the jack on the SIDE of the TELEPHONE BASE.
2. Insert the modular plugs of the STRAIGHT (not coiled) cord into the modular jack
at the REAR of the TELEPHONE BASE and into the TELEPHONE WALL JACK
(either end can be plugged in).
NOTE: Even when your phone is set to pulse service, this phone can be switched to
temporary tone dialing for access to services that require tone signaling like
computer systems. Just press the button after dialing in pulse and your
buttons can now be used for tone signaling for this call only.
RINGER ON/OFF SWITCH
This switch is located on the rear of the set. Select the desired function of the ringer.
ON - Normal setting, rings on incoming calls.
OFF - The ringer does not sound, for undisturbed privacy.
NOTE: If your RINGER switch is in OFF position, only THIS phone will not ring, other
phones in your home on the same line will ring.
TONE/PULSE SWITCH
Select the type of dialing that you desire or that your telephone system requires.
TONE -The phone will operate using tone dialing. (If your phone doesnt dial out,
switch to PULSE.)
PULSE -The phone will dial using rotary pulse dialing .
NOTE: When installation is completed, pick up the HANDSET to listen for dial tone
before using speakerphone or headset for the first time.
This set is designed to
connect directly to a
modular jack
If you have a 4-prong style
jack, simply use a modular
adaptor (not included).
MODULAR JACK
TELEPHONE LINE
(4-prong style jack)
6
PH-319021201 MS V.1
E