Filter
Top Products
IB-PH568-WM-E-040506
1.HANDSET CLIP - When the phone is mounted on the wall, the HANDSET CLIP must be
adjusted so it will hold the HANDSET.
A. SLIDE OUT B. REVERSE C. REPLACE INTO PHONE
NOTE: For either desk use or wall mounting, you need to install the included adaptor.
If you do not have a modular wall phone plate installed, please consult with your phone
company or installer to get one.
2.At all times (to use a desk phone and as a wall phone) you
must use the plastic (box shape) WALL MOUNT ADAPTOR,
please install the WALL MOUNT ADAPTOR following the
arrow and the description on the adaptor.
4.Put the phone over the wall plate, make sure
both posts fit into slots on the back of the phone.
Then slide the phone down to lock the phone
into the wall plate.
DESK USE / WALL MOUNTING
3.Connect the telephone line cord. If you use wall
mounting, in order to avoid the exposing of the
long telephone cord, please use the supplied short
wall cord, plug one end into the LINE 1 (L1 for L1/
L2) jack, route the cord into the channel at the
phone back, and the other end into the wall jack.
14
5.Connect the AC adaptor (see page 7) and another line cord (if you connect two single-
line telephone jacks, see page 8).
For desk use, install
bracket with this arrow
facing up and in upper
part of phone
For wall mounting, install bracket
with this arrow facing up and
install bracket on lower part of
phone
Tab hidden for
desk use
Tab sticks up for
wall mounting
IB-PH568-WM-E-040506(RTT).pmd 7/4/2006, 4:28 PM16