Kyocera 1155 Amplified Phone User Manual


 
Resetting the phone
If the screen seems frozen and the keypad does not
respond to keypresses, reset the phone by completing
the following steps:
1. Remove the battery door.
2. Remove and replace the battery.
If the problem persists, return the phone to the dealer for
service.
Qualified service
If you are experiencing problems with your phone, see
“Getting Help” on page 35. If you have additional
questions, contact your service provider for technical
support. If the problem persists, return the phone with all
accessories and packaging to the dealer for qualified
service.
Accessories
Use only Kyocera-approved accessories with Kyocera
phones. Use of any unauthorized accessories may be
dangerous and will invalidate the phone warranty if said
accessories cause damage or a defect to the phone.
To shop online for a Hands-free Car Kit and other phone
accessories, visit www.kyocera-wireless.com/store.
To order by phone, call (800) 349-4188 (U.S.A. only) or
(858) 882-1410.
Radio Frequency (RF) energy
Your telephone is a radio transmitter and receiver. When
it is on, it receives and sends out RF energy. Your service
provider’s network controls the power of the RF signal.
This power level can range from 0.006 to 0.6 watts.
In August 1996, the U.S. Federal Communications
Commission (FCC) adopted RF exposure guidelines with
safety levels for hand-held wireless phones. These
guidelines are consistent with the safety standards
previously set by both U.S. and international standards
bodies in the following reports:
ANSI C95.1 (American National Standards Institute,
1992)
NCRP Report 86 (National Council on Radiation
Protection and Measurements, 1986)
ICNIRP (International Commission on Non-Ionizing
Radiation Protection, 1996)
Your phone complies with the standards set by these
reports and the FCC guidelines.
Battery and Charger Specifications
093 453 037
Kyocera Wireless Corp.
10300 Campus Point Drive, San Diego, CA 92121 U.S.A.
Visit us at www.kyocera-wireless.com
To purchase accessories, visit
www.kyocera-wireless.com/store
Charger Input Output
CV90-B1523-1 100-240VAC / 50/60Hz 4.4V 1A
CV90-60858-1 100-240VAC / 50/60Hz 4.5V 1.5A
CV90-B1501-1 100-240VAC / 50/60Hz 4.4V 1A
CV90-61016-1 100-240VAC / 50/60Hz 4.5V 1.5A
CV90-60859-1 120VAC / 60Hz 5.2V 400mA
Standard Battery: 3.6V / 975mAh