Filter
Top Products
refer to Line
3
for 'Y' adapter connection instructions.
b. Connect the other end of the Dual RCA Cable to the Left/Right Audio Input Jacks on the transmitter.
WARNING: DO NOT connect the Dual RCA Cable to the speaker terminals of the TV or Audio Source. This
may damage
your transmitter and/or your audio source.
3. If no Audio Output Jacks are available - Connect to headphone Jack using 'Y' Adapter Cable and Dual
RCA patch cord
(both included)
a. Connect the color coded, left (white) and right (red) ends of the Dual RCA Cable to the 'Y' Adapter Cable.
b. Connect the 1/8" headphone plug on the 'Y' Adapter Cable to the headphone input jack located on your
audio source. If
your audio source requires a 1/4" headphone plug, you will require a Headphone Jack Adapter Plug (not
included) then
insert into your source's headphone output jack.
c. Connect the other end of the Dual RCA Cable to the Left/Right Audio Input Jacks on the rear of the
transmitter.
Operation
1. Transmitter Operation and Adjustment
a. Turn on power to your audio source (TV, Portable Device, etc.) to which the transmitter is connected.
NOTE: If transmitter
is connected to the audio variable level outputs, adjust the volume of the source (TV, etc.) to desired listening
level. If
transmitter is connected to fixed-level outputs, no volume adjustment is needed.
b. Adjust the Power On/Off Switch to channel 1 or 2 (choose the same channel as the channel selected on the
headphones).
2. Headphone Operation and Adjustment
a. Insure that you have inserted 2 "AA" batteries in the headphone battery compartment.
b. Turn On/Off Switch to the 'On' position. Power indicator on headphones should light up.
c. Adjust Channel Selector to match channel selected on the transmitter. Stand 10-15 feet away from the
transmitter.
d. Place headphones over your ears and adjust volume to your desired listening level. NOTE: If signal
interference occurs,
adjust the channel selection on both the headphone and transmitter.
3. To preserve your batteries and electricity, when not in use turn the Power Switch to the 'Off' position on the
headphones
and transmitter.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the party responsible for the compliance could void the
user's
authority to operate the equipment.
http://koss.com/koss/kossweb.nsf/pmbyunid/E7D4135ED2903AFF86257...
2 of 3 9/29/2011 10:43 A
M