Filter
Top Products
ASSEMBLY
NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.
w
STEP 3
Attach Middle Base (2) to Rear Base
(3) with Bolts (32), Washers (41) and
Nylon Lock Nuts (42).
Insert Guide Rods (8) into Middle Base
(2). Make sure that the threaded end
of the Guide Rods points up.
Slide Weight Bumbers (45) down to
bottom of Guide Rods (8).
Slide qty 9 of the 10 lb plates (27) onto
the guide rods.
Slide qty 10 of the 5 lb plates (28) onto
the guide rods.
Slide selector rod assembly onto guide
rods.