Filter
Top Products
■ KMC-9B
Desktop Microphone
■ KMC-27
Microphone
(MIL-SPEC noise-canceling)
■ KMC-28
Keypad Microphone
(MIL-SPEC noise-canceling)
■ KCT-18
Ignition Sense Cable
■ KCT-22
Remote Control Cable
■ KCT-23
DC Power Cable
■ KES-5
External Speaker (20W)
■ KCH-14
Basic Remote
Control Head
■ KCH-15
Full-Featured Remote
Control Head
■ KRK-5
Single Control Head Remote Kit
■ KRK-6DH
Dual Control Head Remote Kit
■ KPG-94
Keyloader Interface Cable
■ VGS-1
Voice Guide & Storage Unit
Applicable MIL-STD & IP
ADS#43807 Printed in USA
JQA-QMA1205
All accessories and options may not be available in all markets.
Contact an authorized Kenwood dealer for details and complete
list of all accessories and options.
Options Specifications
Model TK-5710 TK-5710H TK-5810 TK-5810H
GENERAL
Frequency Range
Type 1
136-174 MHz 450-520 MHz
Type 2
400-470 MHz
Number of Channels 512
Zones 50
Max. Channels per Zone
250
Channel Spacing
Analog 12.5 / 15 / 20 / 25 / 30 kHz 12.5 / 25 kHz
Digital 12.5 kHz
Operating Voltage 13.6V DC ± 15% 13.4V DC ± 15% 13.6V DC ± 15% 13.4V DC ± 15%
Current Drain
Standby Less than 0.6A
Receive Less than 2.3A
Transmit Less than 12A Less than 25A Less than 14A Less than 28A
Duty Cycle Transmit: 20%
Operating Temperature Range -22 ˚F to +140 ˚F (-30 ˚C to +60 ºC)
Frequency Stability ± 2.0 ppm (-22 ˚F to +140 ˚F)
Antenna Impedance
50 Ω
Dimensions (W x H x D)
RF Deck only 7.01 x 2.36 x 7.68 in. 7.01 x 2.36 x 12.87 in. 7.01 x 2.36 x 7.68 in. 7.01 x 2.36 x 12.87 in.
(178 x 60 x 195 mm) (178 x 60 x 327 mm) (178 x 60 x 195 mm) (178 x 60 x 327 mm)
with KCH-14 or15 7.05 x 2.36 x 9.09 in. 7.05 x 2.36 x 14.29 in. 7.05 x 2.36 x 9.09 in. 7.05 x 2.36 x 14.29 in.
(179 x 60 x 231 mm) (179 x 60 x 363 mm) (179 x 60 x 231 mm) (179 x 60 x 363 mm)
Weight RF Deck only 5.3 lbs. (2.4 kg) 8.6 lbs. (3.9 kg) 5.5 lbs. (2.5 kg) 9.2 lbs. (4.2 kg)
with KCH-14 5.9 lbs. (2.7 kg) 9.2 lbs. (4.2 kg) 6.2 lbs. (2.8 kg) 9.9 lbs. (4.5 kg)
with KCH-15 5.9 lbs. (2.7 kg) 9.2 lbs. (4.2 kg) 6.2 lbs. (2.8 kg) 9.9 lbs. (4.5 kg)
FCC ID
Type 1
K4435753110 K4435753210 K4439923110 K4439923210
Type 2
K4439923120 K4439923220
IC Certification
Type 1
282F-35753110
Type 2
282F-39923120
RECEIVER (Measurements made per EIA/TIA-204-D)
Sensitivity
Digital (5% BER) 0.25 µV
Digital (1% BER) 0.40 µV
Analog 12 dB SINAD 0.25 µV
Selectivity
Digital -63 dB
Analog @ 25/30 kHz -83 dB / -85 dB -83 dB / -
Analog @12.5/15 kHz -76 dB / -80 dB -76 dB / -
Intermodulation Distortion (Digital & Analog)
-80 dB
Spurious Response (Digital & Analog)
-90 dB
Audio Distortion
Digital Less than 1.0%
Analog Less than 2.0%
Audio Output
Internal (KCH-14) @3% 1.5 W at 8 Ω
@5% 1.625 W at 8 Ω
External @3% 12 W at 4 Ω
@5% 13 W at 4 Ω
TRANSMITTER (Measurements made per EIA/TIA-152-C)
RF Output Power
50 W to 5 W 110 W to 50 W 45 W to 5 W 100 W to 50 W
*2
Spurious & Harmonics 80 dB
FM Hum & Noise
Analog @ 25 kHz 50 (53)
*1
dB 50 dB
Analog @12.5 kHz 45 (47)
*1
dB 45 dB
Microphone Impedance 600 Ω
Audio Distortion Less than 2%
Modulation 16K0F3E, 11K0F3E, 8K10F1E, 8K10F1D
20K0F7D, 11K2F7D, 14K4F1D, 7K20F1D
8ft./17ft./25ft.
footnotes from Front:
1
Intercom: Dual Head capable remote mounts only.
2
KCT-18 ignition sense cable option required.
3
DB-25 ACC: I/O's for dispatch consoles, desktop remotes, vehicle
intercom/PA units, motorcycle PTT/headset kits, PC Laptop /Data
Modems, GPS/AVL Modems; DB-25 (9 Prog. AUX I/O's & 2 Prog.
AUX Outputs); 1 Prog Input (on Control Head).
4
KPG-95D Software required (Windows 98/ NT/ 2000/ Me/XP
compatible).
5
Easy Option Ports: VGS-1, ANI & Scrambler board ports; only 2
ports can be used simultaneously.
6
P25 Trunking option required.
7
Two-Tone: Decode (4 sets x 4 pairs each); Encode: 32 pairs;
Operator Selectable Tone (40 QT.DQT code pairs).
8
DTMF Encode: PTT ID, Emergency ANI, Manual Encode (KMC-28),
Auto-Dial (9 numbers); DTMF Decode: Primary/secondary ID, Stun
(a.k.a. dead beat disable).
9
Operates for 2-Tone, DTMF, FleetSync selective calling.
10
FleetSync & FleetSync II are not compatible.
11
Feature/Option added to the TK-5710 Version 2 radios (SN
80600001 or later).
12
KPG-94 adapts the Motorola‚ KVL3000/3000 Plus Key Loader to
the TK-5710/5810.
(*1) 148MHz ~ 168MHz
(*2) Type 1: 100W to 50W for 450-500MHz. More than 60W to 50W
for 500-520MHz.
Type 2: 100W to 50W for 400-470MHz.
Analog measurements made per TIA/EIA 603
Digital measurements made per TIA/EIA 102CAAA
FleetSync® is a registered trademark of Kenwood Corporation.
Windows® is a registered trademark of Microsoft Corporation in the United States
and other countries.
IMBE
TM
is a trademark of Digital Voice Systems Inc.
The P25 Logo is used under license and is a registered trademark of the Project 25
Technology Interest Group.
Kenwood follows a policy of continuous advancement in development.
For this reason specifications may be changed without notice.
Standard MIL 810C MIL 810D MIL 810E MIL 810F
Methods/Procedures Methods/Procedures Methods/Procedures Methods/Procedures
Low Pressure 500.1/Procedure I 500.2/Procedure I, II 500.3/Procedure I, II 500.4/Procedure I, II
High Temperature 501.1/Procedure I, II 501.2/Procedure I, II Cat.A1 501.3/Procedure I, II Cat.A1 501.4/Procedure I, II
Low Temperature 502.1/Procedure I 502.2/Procedure I, II Cat.C1 502.3/Procedure I, II Cat.C1 502.4/Procedure I, II
Temperature Shock 503.1/Procedure I 503.2/Procedure I Cat.A1,C1 503.3/Procedure I Cat.A1,C1 503.4/Procedure I, II
Solar Radiation 505.1/Procedure I 505.2/Procedure I 505.3/Procedure I 505.4/Procedure I
Rain 506.1/Procedure I, II 506.2/Procedure I,II 506.3/Procedure I, II 506.4/Procedure I, III
Humidity 507.1/Procedure II 507.2/Procedure II 507.3/Procedure II 507.4
Salt Fog 509.1/Procedure I 509.2/Procedure I 509.3/Procedure I 509.4
Dust 510.1/Procedure I 510.2/Procedure I, II 510.3/Procedure I 510.4/Procedure I, III
Vibration 514.2/Procedure VIII, X 514.3/Procedure I Cat.8,II Cat.3 514.4/Procedure I Cat.8,II Cat.3 514.5/Procedure I Cat.20,II Cat.5
Shock 516.2/Procedure I, II, III, V 516.3/Procedure I, IV, V, VI 516.4/Procedure I, IV, V, VI 516.5/Procedure I, IV, V, VI
International Protection Standard
Dust & Water Protection IP54