Kenwood TK-480 Two-Way Radio User Manual


 
29
To make a call by storing and sending:
1 Enter the desired digits using the front panel
keypad.
The digits appear on the display as you enter them.
2 After entering the complete number, press the
PTT switch.
If you are using the transceiver in a Conventional
system, the DTMF code is transmitted after pressing
the PTT switch.
If you are using the transceiver in a Trunking system,
the DTMF code is transmitted after a connection is
established. Releasing the PTT switch before a
connection is established will stop the transmission
from occuring.
If you are using the transceiver in a RIC (Repeater
Inter-Connect) Trunking system, the DTMF code is
transmitted after a connection with the telephone
system is established. If you press the key
programmed as Auto Tel instead of the PTT switch,
the call will automatically connect to the repeater, and
the DTMF code will be transmitted.
Note:
You can only store up to 16 digits before sending. Entering
more than 16 digits will cause an error tone to sound.
If you switch the power OFF before sending the number, the
number will be cleared from memory.