Filter
Top Products
Nov-06
Installation/Tuning Charges for the TK-280/380 Series Radios
Model Description List
%start labor codes
L-836
Assemble KMB-16 with six KSC-24's (Rapid Rate, 120 Volt version only)
15.00
L-961
Assemble KMB-23 with six KSC-24/25/32 (Rapid Rate, 120 Volt versions only)
17.00
L-855
TK-280/380 Programming (with basic TX/RX check)
25.00
L-856
Configure TK-280/380 for Intrinsically Safe (Must Order KNB-17BK)
70.00
L-980
Configure TK-280/380/480/481/385 (KNB-22NC for Intrisically Safe (Must Order KNB-22NC)
70.00
L-901
Program and install QE-2 MDC1200 Encoder
75.00
L-902
Program and install QE-2 G-Star® Encoder
75.00
PassPort® Options (Kenwood-installed)
FOR NEW RADIO ORDERS ONLY
Ordering Instructions
Model Description List
L-938
Install PassPort® ESN options and firmware; NO CHARGE for new TK-280/380/780/880 orders
Note: Only current 80-Series Version 2.0 production radios (“Ver. 2.0” appears on FCC ID label)
0.00
PassPort® Radio Programming Software
KPG-63DK
PassPort® Radio Programming Software V2.00 or higher
65.00
PassPort® Options (Field-installation kits)
FOR DEALER / OPERATOR FIELD CONVERSIONS
Ordering Instructions
1. Order the ESN key/firmware Labor Code options: L-892, L-893 or L-894; specify model radio(s).
Pre-loaded ESN hardware key(s) with the ordered quantities of ESN's and a PassPort® radio firmware diskette will be shipped (100 ESN’s
maximum per hardware key). Important: Any depleted key previously registered to a technicians computer must be retained to
register any new purchased key to the computer; please retain the old key until the new one is received.
2. Other required items:
a. KPG-64D: PassPort® ESN Install Program: the KPG-64D only needs to be ordered one time. It is re-usable for subsequent ESN orders
(unless an upgrade is recommended).
b. KPG-63D Radio Programming Software: required to program all PassPort® parameters for all PassPort® enabled radios, the KPG-63D will
not program LTR or conventional parameters.
c. KPG-49D Radio Programming Software: required only if LTR or conventional systems are also tbe programmed in the PassPort® radio.
3. The KPG-49D radio programming software is required for LTR & conventional site programming
2
.
For VHF/UHF models TK-280/780/380/880 new radio orders, the Kenwood-installed PassPort® ESN / firmware option is no charge:
Order the PassPort® ESN/Firmware option L-938 for each PassPort® radio.
Other required items:
a. KPG-63D Radio Programming Software: the KPG-63D is required to program all PassPort® parameters for all PassPort® enabled
radios, the KPG-63D will not program LTR or conventional parameters.
b. KPG-49D is required only if LTR or conventional systems are to also be programmed in the PassPort® radio.
Page 4 of 5 TK-280_380