Kenwood TK-3302 Two-Way Radio User Manual


 
5
chArging the BAttery pAck
ATTENTION: Always switch OFF a transceiver equipped with a
battery pack before inserting the transceiver into the charger.
1 Plug the AC adapter cable into
the jack located on the rear of the
charger.
2 Plug the AC adapter into an AC
outlet.
3 Slide a battery pack or a
transceiver equipped with a
battery pack into the charging
slot of the charger.
Make sure the metal contacts of
the battery pack mate securely
with the charger terminals.
The indicator lights red and
charging begins.
Charging slot
Indicator
4 When charging is completed, the indicator lights green.
Remove the battery pack or the transceiver from the
charging slot of the charger.
It takes approximately 3 hours to charge the battery pack.
When the charger will not be used for a long time, unplug the
AC adapter from the AC outlet.
Note:
When the indicator blinks red, the battery pack is either defective or
the battery pack contacts are not properly mated with those of the
charger.
The ambient temperature should be between 41°F and 104°F (5°C
and 40°C) while charging is in progress. Charging outside this range
may not fully charge the battery.
The battery pack life is over when its operating time decreases even
though it is fully and correctly charged. Replace the battery pack.