Kenwood NX-800 Two-Way Radio User Manual


 
20
DTMF (DUAL TONE MULTI FREQUENCY) CALLS
Note: DTMF calls can be made only in analog Operation.
mAking A dTmF cAll
Manual Dialing (Microphone Keypad Only)
1 Press and hold the microphone PTT switch.
2 Enter the desired digits using the microphone keypad.
The corresponding DTMF tones sound each time you press a key.
If you release the microphone
PTT switch, transmit mode will end even if the
complete number has not been sent.
Keypad Auto PTT (Microphone Keypad Only)
If your dealer has activated the Keypad Auto PTT function, simply press the
microphone keys to make the call.
The DTMF code will be sent automatically when you press a key.
Store & Send
1 Press the key programmed as Autodial.
2 Enter the desired digits using the microphone keypad.
The digits appear on the display as you enter them.
Alternatively, you can enter digits by using
the / keys {page 14}.
You can enter up to 30 digits before transmitting.
3 After entering the complete number, press the microphone PTT switch or
the key to transmit.
Note: If you switch the power OFF before transmitting the number, the number will be cleared.
AuTodiAl
Autodial allows you to quickly call DTMF numbers that have been programmed
onto your transceiver.
1 Press the key programmed as Autodial, or access the Autodial function
through the Menu {page 12}.
The first entry in the Autodial list appears on the display.
2 Press the / keys or enter the appropriate DTMF number (01 ~ 32) to select
your desired Autodial list number.
The stored entry appears on the display.
3 Press the microphone PTT switch to make the call.
STun code
This function is used when a transceiver is stolen or lost. When the transceiver
receives a call containing a stun code, either transmit mode will be disabled,
or both receive mode and transmit mode will be disabled. The stun code is
cancelled when the transceiver receives a call with a revive code.