Filter
Top Products
4 5
English
English
In time,rechargeable batteries gradually lose the ability to deliver their full power.To
maintain the performance of your JABRA SP100 it is advisable to periodically fit a new
pair of rechargeable batteries.Follow these instructions for fitting either a new set of
rechargeable 1.2-volt (AA) batteries or a pair of non-rechargeable 1.5 volt (AA) Alkaline
batteries. If you choose to use non-rechargeable batteries DO NOT use the AC
adapter or the vehicle power charger with the JABRA SP100.
1. Remove the back cover from the speakerphone using a screwdriver and insert both
rechargeable batteries (or non-rechargeable Alkaline batteries) into their individual
battery compartments as indicated.Re-attach the back cover to the speakerphone.
(See Fig.2)
2. Rechargeable batteries must be fully charged before the speakerphone is used.
Replacing the batteries
3
“Pair”
2
(Connect) with your Bluetooth mobile phone
4
4. Your phone should find the “JABRA SP100”speakerphone and ask if you want to
pair with it.Confirm by pressing “yes”or “ok”.
5 Enter passkey or PIN
3
= 0000 (4 zeros), then press “yes” or “ok”
IMPORTANT: If pairing was successful,the blue indicator light will briefly flash rapidly
before going back to flashing blue every 3 seconds.If unsuccessful,the light remains
solid,and you’ll need to re-attempt pairing.(See steps 3–5 above)
* Phone-specific pairing instructions can be found online at www.jabra.com/fscs
1. Turn the JABRA SP100 on.
2. Press and hold and the mute button until you see a solid blue light
(approximately 5 seconds),then release.
3. Set your Bluetooth phone to “discover”the speakerphone by following your
phone’s instruction guide.Typically,the steps involve going to a “setup”,“connect”,
or “Bluetooth” menu on your phone and then selecting the option to “discover”a
Bluetooth device*.(See example from a Sony Ericsson T610 in Fig.3)
USING YOUR JABRA SP100
Before using your JABRASP100,ensure that the batteries are charged and the JABRA
SP100 is paired with your Bluetooth mobile phone and switched on.
Using your mobile phone’s keypad
1. Dial number on keypad.
2. Press phone’s “send”key.
Using voice-dialing (if supported by your phone)
1. Press and release once.You’ll hear 1 short beep while doing this.
2. You’ll then hear the voice-activation tone;say the name of the person you wish to call.
NOTE: Record voice tag via your mobile phone.
Making a call
5
•
Press and release once
OR
•
End call from your mobile phone’s keypad
Ending a call
6
Answering a call
7
•
After you hear the ring tone,press and release once
OR
•
Answer the call with your mobile phone’s keypad. You may then need to transfer the
call to the speakerphone by pressing and releasing once (depending on
your phone)
Fig. 3
Fig. 2
SP100 User Guide_NA.qxd 5/7/04 2:46 pm Page 4