Grandstream Networks GXP21XX IP Phone User Manual


 
GRANDSTREAM GXP21XX/GXV3140/GXV3175 SERIES PHONES 20-BD5320-00
©
2011 GRANDSTREAM PAGE 19 OF 45
4.3.1 Bob’s Phone Configuration
The following steps are used to configure line 1 for Bob’s phone. This line rings when Bob
is called, so it has Bob’s authentication information.
Step Command Purpose
Step 1
Configure Line Key 1 in Basic
Settings page as Shared.
Line Key 1
Key Mode = "Shared Line”;
Configure the line as “shared”
(as opposed to “private”).
Step 2
Set Register User ID for Account1.
Example:
SIP User_ID = "2405551111_1" ;
The register user ID must
correspond with the line/port
setting on BroadWorks.
Step 3
Enable SIP Authentication for
Account1.
Example:
Authenticate ID = "bobsmith" ;
Authenticate Password = "bobs" ;
If the Authentication service is
configured on BroadWorks,
these parameters must be
configured to match the
BroadWorks settings.
This line rings when Bob is
called, so it has Bob’s
authentication information.
Step 4
Configure display name for
Account1.
Example:
Account Name = “Bob Smith” ;
Configure the name to be
displayed on the device for this
line.
The following steps are used to configure line 2 for Bob’s phone. This line rings when Joe
is called, so it has Joe’s authentication information.
Step Command Purpose
Step 1
Configure Line Key 2 in Basic
Settings page as Shared.
Line Key 2
Key Mode = "Shared Line” ;
Configure the line as “shared”
(as opposed to “private”).
Step 2
Set Register User ID for Account2.
Example:
SIP User_ID = "2405552222_2" ;
The register user ID must
correspond with the line/port
setting on BroadWorks.
Step 3
Enable SIP Authentication for
Account2.
Example:
Authenticate ID = "joebrown" ;
Authenticate Password = "joeb" ;
If the Authentication service is
configured on BroadWorks,
these parameters must be
configured to match the
BroadWorks settings.
This line rings when Joe is
called, so it has Joe’s
authentication information.
Step 4
Configure display name for
Account2.
Example:
Account Name = “Joe Brown” ;
Configure the name to be
displayed on the device for this
line.