Grandstream Networks GXP-1200 IP Phone User Manual


  Open as PDF
of 6
 
5
1. IP address, subnet mask and gateway IP or available DHCP.
2. SIP server and/or Outbound Proxy FQDN or IP address.
3. User subscriber information: User ID, Authentication ID, Password
(provided by your VoIP service provider).
4. GXP-1200 supports “Plug N Call” if your ITSP (Internet Telephony
Service Provider) provides this automatic provisioning service. Ensure
the phone has an internet connection (either DHCP or static IP in your
internet ready network), then power up the phone.
5. Please contact your ITSP for additional settings that may be necessary to
configure the phone.
Configure the GXP-1200 using the Keypad
1. Make sure the phone is idle.
2. Press the “OK” button to enter the keypad MENU to configure the phone.
3. Follow MENU options to configure the basic features of the phone – for
example: the IP address if using a static IP. For details, please check
GXP Series User Manual.
Using the Keypad
1. To enter the MENU, press round MENU button.
2. Navigate the menu by using the UP/DOWN and LEFT/RIGHT.
3. Press the round MENU button to confirm a menu selection.
4. To delete an entry by pressing the MUTE button.
5. The phone automatically exits MENU mode with an incoming call, the
phone is off-hook or the MENU mode if left idle for 20 seconds.
GXP-1200 Key Pad Configuration Menu
Call History
Displays histories of incoming, dialed and missed
calls.
Status
Displays the network status, account statuses,
software version and MAC-address of the phone.
Phone Book
Displays the phonebook.
Instant Messages
Goes to Instant Messages if the Presence if
supported by the service provider or PBX.
Direct IP call
Displays the IP-call options menu.
 previous