Filter
Top Products
6
NOTE: Use only the Thomson 5-2430 (black)/5-2431 (white) power supply
that came with this unit. Using other adapters may damage the unit.
INSTALLATION & SETUP
1. Make sure that the power supply cord is plugged
into the POWER 12V DC jack on the base and into an
AC outlet.
2. Plug the telephone line cord into the PHONE LINE
jack on the base and into a modular jack.
3. Set the TONE/PULSE switch to TONE for touch-tone
service, or PULSE for pulse (rotary) service. If you
don’t know which type of service you have, check
with the phone company.
4. Slide the base RINGER switch to ON if you want the
unit to ring for incoming calls. (The RINGER switch
is located on the same side of the base as the
antenna.)
5. Raise the base antenna.
POWER DC 12V
TONE PULSE
PHONE LINE
RINGER
OFF ON
2
4
5
3
1
NOTE: For conve-
nience, attach the
headset hook to the
slots at the back of
the base. You can rest
the headset here
when you are not
using it.