Filter
Top Products
5
-
-
+
+
Battery clip
Battery
MODULAR JACK REQUIREMENTS
You need an RJ11 type modular jack, which is the most common
type of phone jack and might look like the one pictured here. If
you don’t have a modular jack, call your local phone company to
find out how to get one installed.
INSTALLING THE BATTERY
In the event of a power loss, a 9-volt alkaline battery (not included) enables
the answering system to retain messages stored in memory. To install the
battery:
1. Remove the battery compartment door on the bottom of the unit by
loosening the screw with a Phillips screwdriver. Lift the door.
2.Connect a fresh 9-volt alkaline battery (not included). The large and
small contacts on the battery clip and the battery will interlock. Once
connected, place the battery inside the battery compartment.
3.Replace the battery compartment door and tighten the screw.
NOTE: If the battery is low or not installed, the unit announces “Low Battery” at the end
of your messages.
Battery
compartment