Filter
Top Products
6
DESKTOP INSTALLATION
1. Set the TONE/PULSE switch to TONE for touch-tone service, or PULSE
for pulse (rotary) service. If you don’t know which type of service you
have, check with the phone company.
2. Set the RINGER switch to ON so the handset rings for incoming calls.
3. Plug the power supply cord into the base and into an AC outlet.
4. Raise the base antenna.
5. Place handset in the base. Allow the phone to charge for 12 hours
before using the first time. The CHARGE/IN USE light comes on indicat-
ing that the battery is charging. If you don’t charge the handset
battery properly (for 12 hours) when you first set up the phone,
performance of the battery will be compromised.
6. After charging, connect the telephone line cord to the phone and then to
the wall jack.
NOTE: Use only the Thomson power supply # 5-2429 that is compatible with
this unit. Using other adapters may damage the unit.
T/P switch
1
2
6
4
5
3
NOTE: For desktop charging, the
handset is able to charge facing up
or facing down.