Filter
Top Products
16
Area Code
From the Handset Setup Menu:
1. Press the vol/CID ( 6 or 5) button to scroll to the AREA CODE sub-menu.
2. Press the menu ok/mute button to enter the menu. SET AREA CODE - - - shows in the
display. The default setting is - - -.
3. Use the touch-tone pad to enter your 3-digit area code.
4. Press the menu ok/mute button to confirm. You will hear a confirmation tone and the new
area code shows in the display.
NOTE: To restore the default setting to - - -, press and release the del/conf/
intercom button when SET AREA CODE shows in the display.
Tone/Pulse
From the Handset Setup Menu:
1. Press the vol/CID ( 5 or 6) button to scroll to the TONE PULSE sub-menu.
2. Press the menu ok/mute button to enter the menu. TONE/PULSE 41TONE 2PULSE shows
in the display. The default setting is “1 TONE”.
3. Use the touch-tone pad or vol/CID ( 5 or 6) to enter 1 TONE or 2 PULSE.
4. Press the menu ok/mute button to confirm. You will hear a confirmation tone and your
selection shows in the display.
Registration
Your packaged handset(s) are pre-registered and ready to use. It is not recommended that
a handset be registered again unless absolutely necessary.
From the Handset Setup Menu:
1. Press the vol/CID ( 6 or 5) button to scroll to the REGISTRATION sub-menu.
2. Press the menu ok/mute button to enter the menu. REGISTRATION 1YES 42NO shows in
the display. The default setting is 2NO.
3. Use the touch-tone pad to select 1 for YES or 2 for NO. Or use the vol/CID ( 6 or 5) button
to scroll to 1YES or 2NO.
4. If you select YES, press the menu ok/mute button. HOLD BASE PAGE FOR 5 SECONDS,
THEN PRESS HANDSET MENU OK shows in the display. (Your handset should be held near
the base during registration process.)