Filter
Top Products
16
. Plug one end of the straight telephone line cord into the jack on
the bottom of the base.
5. Feed the line cord through the groove and plug the end into the
modular telephone jack.
6. Slip the mounting holes (on the bottom of the base) over the
wall plate posts and rmly slide the unit down into place.
This section shows you how to set up your answering system to
receive incoming calls. Before you begin the set up process, you
must turn on the answering system.
• Press the button to turn the answering system
on and off. The Message Indicator lights when the answering
system is on. The indicator blinks when you have new
messages.
If you need additional assistance; while in standby mode, press the
button on the base and follow the voice instructions.
Use the (5 or 6) buttons to adjust speaker volume
on the base to a comfortable level. L1 is the minimum speaker
volume and L is the maximum.
For best results when recording, you should be about nine inches
from the microphone, and eliminate as much background noise as
possible.
1. Press and hold the button on the base until the
speaker announces “RECORD ANNOUNCEMENT AFTER TONE".