Filter
Top Products
Getting Started
Before you can use your radio, you must install and charge
the battery and install the antenna as follows.
Charging the Battery
Your radio is powered by a specially-designed,
nickel-cadmium battery. You should fully charge the battery
before operating the radio. Only use the following charger.
Model BML 161 60/1 Desktop Rapid Charger
Follow the charging instructions that come with the charger.
Also, be sure to observe the following warning/safety
information for nickel-cadmium batteries (on page 4 of this
Operator’s Manual).
Attaching/Removing the Battery
To attach the battery to the radio, align the slots in the battery
with the hooks on the radio as shown. Then, slide the battery
toward the top of the radio until it locks into place.
To remove the battery from the
radio, push the battery release
lever toward the front of the
radio and slide the battery
toward the bottom of the radio.
- 9 -