Filter
Top Products
~33~
Paging from Base to Handset
1. Pressing the base unit PAGE or
INTERCOM key, will page all
registered handsets. The first
handset to answer the page will
establish a voice link with the base.
2. The INTERCOM LED will flash until a
handset responds. The light will stay
lit until the link is terminated.
3. The base unit will page for 15
seconds, then terminate the page
if no handset responds.
4. Before a handset answers, the page
can be cancelled from the base by
pressing PAGE again. However,
once a handset answers, only the
answering handset can end the
intercom call.
A page to a handset cannot be initiated from the
base while an incoming call is ringing into the system. The
IN USE LED flashes to indicate an incoming call is in
progress.
NOTE:
Intercom from
Base 1
SILENT
~34~
Paging from Handset to Base
Answer Incoming Calls with a Handset to Base
Intercom Call in progress
For a handset to intercom a base unit, follow the steps below:
1. On the handset press 2-WAY.
2. At the extension prompt, input the 2
digit number for the base unit which
will be a 0 followed by the base unit
number of 1, 2, 3 or 4.
3. The handset LCD will show a paging
prompt:
4. The base will ring once, then
automatically connect the intercom
call from a handset.
There are three options for the handset:
1. Press TALK to switch to the incoming call.
2. Press END to terminate the intercom call and allow the
incoming call to ring on all handsets.
3. Do nothing and ignore the incoming phone call.
Enter
Extension # ??
Paging
extension#:01