Filter
Top Products
DUV1000 User’s Guide
7
3 Getting Started
After installation, DUV1000 is ready for configuration. You need to enter Internet Service Provider
(ISP) and Calling Card information to make and receive Internet phone calls. However, it can
make normal PSTN phone calls without any configuration. Refer to Appendix A to know how to
enter alphanumeric and special characters required for user name and password.
Warning: DUV1000 identifies end of each parameter by ‘#’. Please terminate each parameter
entry by pressing ‘#’ key. For example, to enter the password as ‘123’ you should press ‘123#’.
3.1.1 ISP Information
Following Internet Service Provider (ISP) account information is required for dial-up Internet
connection. Refer to your Internet Service Provider’s card for this information.
¾ Internet Access Telephone Number
¾ User Name
¾ Password
To enter these parameters, follow the steps below. DUV1000 voice menu guides you through the
configuration process.
1. Enter ‘∗123∗#’ to enter the configuration menu.
2. Enter the configuration password. The default password is ‘12345’.
3. Enter ‘1’and then ‘1’again, to edit the ISP parameters. It plays “Please enter the ISP
phone number and terminate by ‘#’ button”.
4. Enter the Internet access phone number and terminate by pressing ‘#’ button. During
entry, it echoes the character pressed.
5. After the termination, it plays back the value, as “You entered xxxx, press ‘1’ to accept, ‘2’
to re-enter. Press ‘1’ to accept the entered parameter. If you want to re-enter the
parameter, press ‘2’.
6. Follow the voice menu to enter ISP User Name and password. After ISP configuration,
phone plays the main menu.
7. Enter ‘5’ to save the ISP information.
3.1.2 VoIP Calling Card Information
Following VoIP (Internet Telephone) calling card information is required for Internet phone
connection. The VoIP service provider will provide these parameters. Refer your calling card for
these parameters. After entering the calling card parameters, your Internet phone number will be
same as user ID.
¾ User ID
¾ Password or PIN
To enter these parameters, follow the steps below and the voice menu from DUV1000.
1. Enter ‘∗123∗#’ to enter the configuration menu.
2. Enter the configuration password. The default password is ‘12345’.
3. Enter ‘2’ and then’1’, to edit the VoIP calling card parameters. It plays “Please enter the
calling card user ID and terminate by ‘#’ button”.
4. Enter the calling card User ID and terminate by pressing ‘#’ button. During entry, it
echoes the character pressed.
5. After the termination, it plays back the value, as “You entered xxxx, press ‘1’ to accept, ‘2’
to re-enter. Press ‘1’ to accept the entered parameter. If you want to re-enter the
parameter, press ‘2’.
6. Follow the voice menu to enter the calling card password.