Filter
Top Products
11
English
Cordless Baby Monitor
If you place the handset near the child (but out of reach), then you will receive
a call if the sound from the child’s room exceeds a set sensitivity level. You will
then be able to hear the child for one minute.
1. Access Baby Monitor according to instructions on previous page.
2. Scroll to desired setting as below with scroll button.
Activ. Activate function off/on.
Call to Select internal call (applies to +1...) or external call.
Level Setting of sensitivity level.
3. Press OK. The display shows Baby Monitor On.
4.
Test the setup before use by shouting into the handset which is to be
placed near the child, and have someone listen to the other unit.
5. To avoid disturbing the child with incoming calls, you can turn
off the ring signal by pressing and holding the
*
key.
6. Turn off the function by selecting OFF.
Important!
The Baby Monitor is a useful help, but it is obviously not a replacement for regular baby care.
Ensure the equipment is always out of the child’s reach. Never place the handset in the cot.
We recommend activating the Call Waiting function on the receiving unit, e.g. a mobile phone,
to avoid missing a call.
Country Code
To copy entries from the SIM card using “+”, it is often necessary to enter
certain information. Telephone numbers on the SIM card that have been
stored with the international dialling code 00 followed by the country code
will also be changed. Example of settings for UK:
Country code (domestic): 44
International prex: 00
National prex: 0
Register
Every new handset must be registered in order to use a base unit. Every base
unit can manage up to 6 different handsets.
See Expanded Systems for more information.
1. Access Register according to instructions on previous page.
2. Scroll to required base unit (√=previous reg.). Press OK.
3.
Enter the base unit PIN code (0000 on delivery). Press OK.
4.
Press down the
J
search button on the base unit until the indicator ashes.
5.
After a few seconds (max 60) any unused handset number will be displayed.
Select one of these by pressing the corresponding key.