Filter
Top Products
Using Other Functions
69
Step by Step
• Group ringing, code:
*
81/#81 (Æ page 80)
• Group call, code:
*
85/#85 (Æ page 80)
• Suppress caller ID,
code:
*
86/#86 (Æ page 26)
• Waiting tone, code:
*
87/#87 (Æ page 15)
• Open door, code:
*
61 (Æ page 21)
• Door opener on/off, code:
*
89/#89 (Æ page 22)
• Control relay, code:
*
90/#90 (Æ page 71)
• Do not disturb, code:
*
97/#97 (Æ page 19)
• Ringer cutoff function, code:
*
98/#98 (Æ page 19)
• Speed-dialing, code:
*
7 (Æ page 41)
• Associated service, code:
*
83 (Æ page 67)
Precondition:
Precondition:Precondition:
Precondition: You have a telephone that uses tone dialing (DTMF di-
aling) or you can switch your telephone to tone dialing. The tele-
phone is not connected to the system.
Set up a call to the system. Enter the station number (contact System
Support).
Wait for a continuous tone (if necessary switch the telephone to tone
dialing), then enter the internal number that has been assigned to you
and the associated PIN.
Enter the code (necessary only if programmed in the system).
Wait for a dial tone and then enter the code, such as
*
97 for Do not
disturb on. Make other inputs as necessary; (refer to the operating in-
structions for pulse and DTMF telephones).
or
oror
or
Dial the external number.
You can only execute one function at a time, or set up only
one outgoing connection.
The connection is immediately released after successful ac-
tivation of a function.
In the case of an external-external call, the connection is re-
leased as soon as either of the parties ends the call.