Filter
Top Products
12
CChhaarrggiinngg tthhee BBaatttteerryy
Before plugging the phone line in to your new phone for the first time, fully
charge the rechargeable battery pack for 14 hours without interruption.
1. Place the Handset on the base.
(The handset will charge either face up or face down).
2. Make sure the red charge light on the base comes on and the number of
your handset appears in the left of the handset display. If the LED doesnt
light, check to see that the AC Adaptor is plugged in and that the handset
makes good contact with the base charging contacts.
3. The battery symbol in the display gradually fills up as it is charged. If your
battery symbol is empty and flashing and you hear a warning beep every
10 seconds, you will need to recharge your handset before you can use it.
4. Once charged, your handset display will be as shown below....
NNOOTTEE
NNOOTTEE
If the belt clip is attached to the handset, you should place the handset face
down in the base.
Only use the battery pack supplied or rechargeable AA Batteries (not supplied)
DDOO NNOOTT UUSSEE SSTTAANNDDAARRDD BBAATTTTEERRIIEESS..
Indicator Status
Steady outline and 4 blocks more than 80%
Steady outline and 3 blocks more than 50%
Steady outline and 2 blocks more than 40%
Steady outline and 1 blocks more than 20%
Steady outline less than 10%
Outline Slow blinking low and beep alarm
Steady outline and running blocks charging
If the battery status is low and in need of recharging, a warning
beep will sound at 30 seconds intervals.
Dectom.qxd 2/09/99 15:59 Page 12