Filter
Top Products
USE THIS TEMPLATE
TO DETERMINE THE POSITION OF
TELEPHONE ON WALL,
AND WHERE TO LOCATE
SCREW HOLES.
USE ONLY FOR WALL
INSTALLATION OF TELEPHONE SET
TOP
MOUNTING HOLE A
REMOVE TEMPLATE FROM
WALL BEFORE INSERTING
PLASTIC ANCHORS OR SCREWS
MOUNTING HOLE B
SET UP
DIAL MODE
The DIAL MODE switch is located at the back of the telephone. Slide the switch to TONE unless you have
Dial-Pulse (Rotary) telephone service in your area, in which case, slide the switch to the PULSE position.
MECHANICAL BELL RINGER
CONTROL
The RINGER CONTROL switch at the back of the telephone
allows you to turn the ringer ON or OFF. You can still make
or receive calls with the ringer in OFF position, however, you
will not hear the incoming ring.
RECEIVER VOLUME
The RECEIVER VOLUME CONTROL switch, located on
the bottom of the telephone, allows you to adjust the
volume of the receiver earphone from LOW and HI.
INSTALLATION
To connect the telephone, connect the line cord from the
back of the telephone to the wall jack.
MAKING AND ANSWERING CALLS
To get a dial tone or answer an incoming call, lift the handset.
To hang up, either replace the handset or press the HANDSET
CRADLE manually.
FLASH
Pressing FLASH sends the electronic equivalent of a switchhook
signal. Use FLASH with special phone company services such
as call waiting.
REDIAL
Pressing redial will call the last number dialed from this phone
IF THERE IS NO DIAL TONE
1) Make sure that all plugs are connected properly. Check
the connections at the wall jack, the telephone cabinet
and handset.
2) Try another modular jack within your home which you
know to be working properly.
IF CALLS CANNOT BE DIALED
OR DIALS SLOWLY
Check to make sure that the DIAL MODE switch is in the
correct position for the type of service (TONE/PULSE)
available in your area.
IF THE TELEPHONE DOES NOT RING
Check that RINGER CONTROL switch is not set to OFF.
If there are several telephones connected to the same line,
try disconnecting some of the other telephones. Having too
many telephones connected to the same line can cause low
ringer volume or poor sound quality during calls.
CARE AND MAINTENANCE
Avoid rough treatment to the telephone. Do not drop the
handset and always place it gently back in the cradle. Clean
only with slightly dampened cloth. Do not use detergent, wax,
solvent, spray, alcohol or excessive water.
PARTS INCLUDED
Your new telephone includes the following items:
1 - Telephone handset
1 - Handset coil cord
1 - Telephone body
1 - 7 Foot line cord
1 - 15 Inch line cord
2 -
Screws
with wall archors
1 - Wall mounting template.
4 - Rubber spacer pads.
2 - Tapping screw
1 - Template (See above picture and instructions)