Filter
Top Products
15
PAUSE BUTTON
PAUSE allows you to insert a 3.6-second pause in the dialing sequence. This is
particularly useful if you are connected to a PABX system where you must dial an
access code (usually the number 9) to obtain an outside line.
1. Press PAUSE and release at any point in the dialing sequence where a
pause is desired.
2. PAUSE can be pressed more than once to create a longer pause.
HOLD BUTTON
1. NORMAL MODE
a. Press HOLD and hang up the handset. HOLD will light up and remain
lighted until you resume your conversation.
b. To resume your conversation, lift the handset or that of any extension
phone on the same line or press and release SPEAKER. The HOLD
indicator will go out and your call can continue.
2. PBX MODE
Press HOLD. The phone will dial out the code. Depending on the PBX, it
may now be necessary to hang up the handset. Note that HOLD will not
light in this mode.
FLASH BUTTON
This telephone provides a line break signal for accessing PABX service or for use
of Call Waiting from your local telephone company. If you have Call Waiting ser-
vice, you can use the Call Waiting function per the following instructions.
1. While having a conversation, another party calls and you hear a tone.
2. Press FLASH once and release. The first conversation is placed on hold and
the second call can be answered.
3. Press FLASH again and release. You may speak to the first caller again and
the second call is placed on hold.
HEADSET BUTTON
The HEADSET button can control the interface to either a corded or wireless
headset. See instructions in INSTALLATION section for operation wtih Plantronics™
wireless headsets.
CORDED HEADSET
This telephone will accept either a 2.5 mm cell phone-style headset or an RJ
type headset. Press HEADSET to connect and disconnect from calls.