Filter
Top Products
To Dial A Phone Number In Memory
1. Lift the handset and wait for a dial tone.
2. To dial an auto memory button (located on top of base) - Press
the desired auto memory button.
3. The number will be dialed automatically.
PAUSE BUTTON
The PAUSE button allows you to insert a 3.6-second pause in the dialing sequence. This
is particularly useful if you are connected to a PABX system where you must dial an
access code (usually the number 9) to obtain an outside line. It can also be used when
storing numbers in memory locations to insert a delay in the dialing sequence.
MESSAGE WAITING LAMP
The Message Waiting Lamp will light when a message is waiting at a properly equipped
PABX or telephone central office. This switch located under plastic memory index
cover allows the phone to be configured for 90V message waiting on T/R (tip/ring, the
red/green wires) or Y/B (the yellow/black wires).
T/R Y/B
If this switch is in T/R Position then the message waiting lamp also serves as visual ring
indicator.
DIP SWITCH
The DIP Switch located under the plastic memory index cover provides for:
a) Positive line disconnect option selection insures that any hookswitch depression
disconnects the call.
b) A-Lead option selection used for special applications such as use with 1A2 Key
Systems.
c) Pause time selection for 2 or 3.6 seconds.
1 2 3 4
On Note: The current settings
are in default position.
Off
POSITION ON OFF
9
1. Positive Line Disconnect YES NO
2. A-Lead YES NO
3. Pause 2 seconds 3.6 seconds