Cobra Electronics PR 255 VP Two-Way Radio User Manual


 
Operation
Customer Assistance
Warranty
IInnttrroodduuccttiioonn
Caring for Your microTALK
®
Radio
Your microTALK
®
radio will give you years of trouble-free service
if cared for properly. Handle the radio gently. Keep the radio away
from dust. Never put the radio in water or in a damp place. Avoid
exposure to extreme temperatures.
Rechargeable Batteries
and Charger
To install or replace batteries:
1. Remove belt clip by releasing belt clip
latch and sliding clip up.
2. Pull up on the battery door latch to
remove the battery compartment cover.
3. Insert the supplied four (4) AAA rechargeable
batteries (also works with non-rechargeable
alkaline batteries). Position batteries
according to polarity markings.
4. Replace battery compartment cover and
belt clip.
To charge batteries in radio:
1. Check to see that the batteries have been
inserted properly. See above for battery
installation instructions.
2. Insert round connector of wall charger/adapter into the charge jack
located at the top of the radio. The wall charger/adapter has two
round connectors which enables you to charge either one or two
radios at a time.
3. Plug the wall charger/adapter into electrical outlet.
It normally takes 15 hours to fully recharge batteries. It is not
recommended to recharge batteries more than 24 hours. Estimated
operation time on a full charge is 8 hours.
Use only the supplied rechargeable batteries and wall charger/adapter
for recharging your Cobra microTALK
®
radio. Non-rechargeable alkaline
batteries can also be used.
IInnsseerrtt BBaatttteerriieess
PPuullll UUpp LLoocckkLLaattcchh
RReemmoovvee BBeelltt CClliipp
11
NNootthhiinngg
Comes Close to a Cobra
®
Radio Charger Jack
9508-PR255-2VP-D-FinalC #17 3/29/06 3:36 PM Page 1