Filter
Top Products
Introduction Operation Customer Assistance
23
Nothing comes close to a Cobra
®
Safety Information for microTALK
®
Radios
Your wireless handheld portable transceiver contains a low power transmitter.
When the talk button is pushed, it sends out radio frequency (RF) signals.
The device is authorized to operate at a duty factor not to exceed 50%.
In August 1996, the Federal Communications Commission (FCC) adopted
RF exposure guidelines with safety levels for handheld wireless devices.
Important:
FCC RF Exposure Requirements: For body-worn operation, this radio has
been tested and meets the FCC RF exposure guidelines when used with
Cobra accessories supplied or designated for this product. Use of other
accessories may not ensure compliance with FCC RF exposure guidelines.
Use only the supplied antenna. Unauthorized antennas, modifications,
or attachments could damage the transmitter and may violate FCC regulations.
Normal Position:
Hold the transmitter approximately five cm (two inches) from your face
and speak in a normal voice, with the antenna pointed up and away.
Trademark Acknowledgement
•
Cobra
®
, microTALK
®
, Nothing comes close to a Cobra
®
and the snake
design are registered trademarks of Cobra Electronics Corporation, USA.
Cobra Electronics Corporation™ is a trademark of Cobra Electronics
Corporation, USA.
The Cobra line of quality products includes
•
CB Radios • microTALK
®
Radios • Radar/Laser Detectors •
Safety Alert
®
Traffic Warning Systems • Handheld GPS Receivers •
Mobile GPS Navigation Systems • HighGear
®
Accessories •
CobraMarine™ VHF Radios • Power Inverters • Accessories
O
peration Customer
Assistance
W
arranty
Notice
English
Trademark Acknowledgement,
Products and Product Service
22
Customer Assistance
Product Service
•
If you have any questions about operation or installing your new
Cobra product, or if you are missing parts…
Please call Cobra first! DO NOT RETURN THIS PRODUCT TO THE STORE!
See customer assistance on page A1.
For Products Purchased in Canada
For out of warranty service, ship this product prepaid to: AVS Technologies
Inc., 2100 Trans Canada Hwy S., Montreal, Quebec, H9P 2N4, www.cobra.ca.
We reserve the right to repair or replace the radio with an equivalent product.
Please include the following information: Date of Purchase, Model Number,
Dealer Purchased From, Dealer Address, Dealer Phone Number.
For Products Purchased in the U.S.A.
If your product should require factory service, please call Cobra first before
sending your radio. This will ensure the fastest turn-around time on your repair.
You may be asked to send your radio to the Cobra factory. It will be necessary
to furnish the following to have the product serviced and returned.
1) For warranty repair include some form of proof-of-purchase,
such as a mechanical reproduction or carbon of a sales receipt.
If you send the original receipt, it cannot be returned.
2) Send the entire product.
3) Enclose a description of what is happening with the radio. Include a typed
or clearly printed name and address of where the radio is to be returned.
4) Pack radio securely to prevent damage in transit. If possible, use the
original packing material.
5) Ship prepaid and insured by way of a traceable carrier such as
United Parcel Service (UPS) or Priority Mail to avoid loss in
transit to Cobra Factory Service, Cobra Electronics Corporation,
6500 West Cortland Street, Chicago, Illinois 60707 U.S.A.
6) If the radio is in warranty, upon receipt of your radio, it will either be
repaired or exchanged depending on the model.
Please allow approximately three to four weeks before contacting Cobra
for status. If the radio is out of warranty, a letter will automatically be sent
informing you of the repair charge or replacement charge. If you have any
questions, please call 773-889-3087 for assistance.
For Products Purchased Outside the U.S.A. or Canada
Please contact your local dealer for product service information.
Warranty
Intro Operation Customer
A
ssistance
Warranty
Notice
Secondary Icons
This device complies with part 15 of the FCC Rules.Operation is subject
to the following two conditions: 1) This device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Warnings: Replacement or substitution of transistors, regular diodes
or other parts of a unique nature, with parts other than those recommended
by Cobra may cause a violation of the technical regulations of part 95 of
the FCC rules, or violation of type acceptance requirements of part 2 of
the rules.