Filter
Top Products
VHF Marine Radio ProtocolsOperatingYour Radio VHF Marine Radio ProtocolsOperatingYour Radio
23
Nothing Comes Close to a Cobra
®
Advanced Operation
22
English
Advanced Operation
Dual-Watch Scan Mode
To enter Memory mode, press Memory/Escape button. The
display will show the MEM icon and the Memory Channel
bank will be activated and displayed.
To Program Memory Locations:
1. Press and hold the Memory/Escape button for
two (2) seconds. The memory location number
will start flashing and the MEM icon will be
turned On.
2. Use the Channel Up and Channel Down buttons to
advance to the memory location (0-9) you want to
program.
3. Press the Memory/Escape button to select the
memory location. The memory channel number
will stop flashing and the channel number will
start flashing.
4. Use the Channel Up and Channel Down buttons
to change to the channel you want to store into the
selected memory location.
5. Press the Memory/Escape button to program that
channel. The memory location number will flash again.
Repeat steps 2 through 5 to program as many additional
memory locations as you want [up to ten (10) VHF memory
channels].
6. Press and hold the Memory/Escape button for
two (2) seconds. This will return the radio to
Memory mode.
7. Press and release the Memory/Escape button
again to return to Marine Standby mode.
MEM/ESC Button
Memory Location Number
Channel Up/Down Buttons
Channel Number
Memory Location Mode
Your radio has ten (10) memory locations (numbered 0 to 9) for your most frequently
used channels. These memory locations can be selected individually or can be scanned.
Dual-Watch Mode
Dual-Watch mode gives you one (1) button access to scan a total of two (2) channels of
most importance to you. Channel 16 is preprogrammed and will always be one (1) of
the scanned locations. The other channel can be any marine VHF channel of your choice.
Using Dual-Watch
1. In Marine Standby mode, select the desired channel for
Dual-Watch scanning.
2. Press the Dual-Watch button. The DW icon will appear
on the LCD display and the radio will scan channel 16
and the selected channel.
3. A signal on any one (1) of the two (2) channels will
stop the scan for 10 seconds to allow you to listen
to the traffic on that location.
NOTE
After the Dual-Watch scan stops to monitor a
channel, as long as you do not press any buttons
within 10 seconds, your radio will automatically
resume scanning the Dual-Watch channels.
4. Press the Channel Up or Channel Down buttons
to resume scanning the Dual-Watch channels or
to change the scan direction.
5. To EXIT the Dual-Watch scan, press the Dual-Watch
button again. The DW icon will disappear from the
LCD and the radio will return to Marine Standby mode.
DUAL-WATCH Button