Filter
Top Products
Operation
3
Operation
2
Pull lock tab down
to remove battery
cover.
Insert four “AAA”
batteries.Position
batteries according
to polarity markings.
Note
Always use high quality
alkaline or NiMH batteries.
Incorrect positioning can
damage both the batteries
and the unit.
Only the Cobra® NiMH
battery (Part #FA-BP)
pack can be recharged.
See Accessories on page 19.
Charge ports for recharging
NiMH (Nickel Metal
Hydride) battery pack are
located on back of unit.
Note
When batteries are low or
need charging the
indicator will blink.Replace
alkaline batteries or
recharge NiMH battery
pack.
Install Batteries
Battery
Installation
1 2
--++
++
--
Turning On Your microTALK®
HOLD
Note
Whenever the unit is on
you can receive
communications.
Turning
On Your
microTALK
®
Illuminating the Display
Illuminating
the Display
1
1
Push and hold the POWER button for
2 seconds.An audible “tone”will indicate the
unit is on,and display will illuminate for 10
seconds.
Push and release LIGHT/MAX RANGE
button to illuminate display for ten seconds.