Filter
Top Products
OPERATION
ENGLISH
Recalling Memory Locations
To recall a channel you have stored in a
memory location:
1. Press the MODE button until the Memory
icon and a memory location flashes.
2. Select your desired
memory location
by pushing the
CHANNEL SELECT
button up or down.
Press the LOCK
button to enter
your selection. To
go on to the next
function without
selecting a memory
location, press the MODE button.
3. Repeat steps 1 and 2 to recall other
memory locations.
Using the Scan Function
Your microTALK
®
radio can automatically
scan main channels (1-14), the privacy
codes (0-38) within one main channel,
or memory locations.
To scan main channels:
1. Press the MODE button until the Scan icon
and main channel number flashes.
2. Push the CHANNEL SELECT button up
or down and the unit will begin scanning
the main channels. (NOTE: The unit
“ignores” privacy codes while scanning
main channels.)
3. The radio will continue to scan all main
channels and stop if an incoming
transmission is detected. The unit will
remain on that channel for 10 seconds.
During that time you can:
a) Press and hold the TALK button and
talk. The radio will remain on that
channel and return to Standby mode.
b) Push the CHANNEL SELECT button
up or down to resume scanning main
channels.
c) Press the MODE button to proceed
to privacy code scanning (see following
page).
If you do not press any button within
10 seconds, the radio will automatically
resume scanning main channels.
9
OPERATION
ENGLISH
Using the Scan Function
(continued)
To scan privacy codes:
1. While in Standby mode, press the
CHANNEL SELECT button up or down to
choose the main channel you wish to scan.
2. Press the MODE button until the Scan
icon and the privacy code number flashes.
3. Push the CHANNEL SELECT button
up or down and the unit will begin
scanning privacy codes within the
main channel you selected.
4. The radio will continue to scan privacy
codes and stop if an incoming
transmission is detected. The unit will
remain on that code for 10 seconds.
During that time you can:
a) Press and hold the TALK button and talk.
The radio will remain on that channel and
privacy code, then return to Standby mode.
b) Pushthe CHANNELSELECT buttonup or
down toresume scanningprivacy codes.
c) Press the MODE button to proceed
to memory location scanning.
If you do not press any button within
10 seconds, the radio will automatically
resume scanning privacy codes.
To scan memory locations:
1. Press the MODE button until the Scan icon,
Memory Location icon and memory
location number flashes.
2. Push the CHANNEL SELECT button up or
down and the unit will begin scanning
memory locations.
10
MODE button
TALK button
MODE button
CHANNEL SELECT
button
CHANNEL SELECT
button
MODE button
MODE button
CHANNEL SELECT
button
MODE button
LOCK
button
CHANNEL
UP
CHANNEL
DOWN