Filter
Top Products
OperationIntroduction Customer Assistance
17
Nothing Comes Close to a Cobra
®
English
16
Safety Information for microTALK
®
Radios
•
Your wireless handheld portable transceiver contains a low power
transmitter. When the talk button is pushed, it sends out radio
frequency (RF) signals. The device is authorized to operate at a duty
factor not to exceed 50%. In August 1996, the Federal
Communications Commission (FCC) adopted RF exposure guidelines
with safety levels for handheld wireless devices.
Important:
FCC RF Exposure Requirements: For body-worn operation, this radio
has been tested and meets the FCC RF exposure guidelines when used
with Cobra accessories supplied or designated for this product. Use of
other accessories may not ensure compliance with FCC RF exposure
guidelines. Use only the supplied antenna. Unauthorized antennas,
modifications, or attachments could damage the transmitter and may
violate FCC regulations.
Normal Position:
Hold the transmitter approximately five cm (two inches) from your face
and speak in a normal voice, with the antenna pointed up and away.
Trademark Acknowledgement
•
Cobra
®
, microTALK
®
, Nothing Comes Close to a Cobra
®
, VibrAlert
®
and the snake design are registered trademarks of Cobra Electronics
Corporation, USA. Cobra Electronics Corporation™ is a trademark
of Cobra Electronics Corporation, USA.
The Cobra line of quality products includes
•
CB Radios • microTALK
®
Radios • Radar/Laser Detectors •
Safety Alert
®
Traffic Warning Systems • HighGear
®
Accessories •
CobraMarine
®
VHF Radios • Power Inverters • Trucker Nav Systems •
LED Lights • Jumpstarters • Accessories
Customer Assistance
Product Service
•
For any questions about operating or installing this new Cobra product,
or if parts are missing…/do not
return this product to the store. See customer assistance on page A1.
For Products Purchased in Canada
If your product should require factory service, please call AVS Technologies
Inc. at 514-683-1771 ext. 2-264 before sending your radio. For out of
warranty service, ship this product prepaid to: AVS Technologies Inc.
(A Division of SYNNEX Canada Limited), 3300 Côte-Vertu, Ste 310 Ville
St-Laurent, Québec, CANADA H4R 2B7, www.cobra.ca. We reserve the right
to repair or replace the radio with an equivalent product. Please include the
following information: Date of Purchase, Model Number, Dealer Purchased
From, Dealer Address, Dealer Phone Number.
For Products Purchased in the U.S.A.
If your product should require factory service, please call Cobra first before
sending your radio. This will ensure the fastest turn-around time on your
repair. You may be asked to send your radio to the Cobra factory. It will be
necessary to furnish the following to have the product serviced and returned.
1) For warranty repair include some form or proof-of purchase, such as a
mechanical reproduction or carbon of a sales receipt.
If you send the original receipt, it cannot be returned.
2) Send the entire product.
3) Enclose a description of what is happening with the radio. Include a
typed or clearly printed name and address of where the radio is to be
returned.
4) Pack radio securely to prevent damage in transit. If possible, use the
original packing material.
5) Ship prepaid and insured by way of a traceable carrier such as United
Parcel Service (UPS) or Priority Mail to avoid loss in transit to Cobra
Factory Service, Cobra Electronics Corporation, 6500 West Cortland
Street, Chicago, Illinois 60707 U.S.A.
6) If the radio is in warranty, upon receipt of your radio, it will either be
repaired or exchanged depending on the model.
Please allow approximately three to four weeks before contacting Cobra for
status. If the radio is out of warranty, a letter will automatically be sent
informing you of the repair charge or replacement charge. If you have any
questions, please call 773-889-3087 for assistance.
For Products Purchased Outside Canada or the U.S.A.
Please contact your local dealer for product service information.
Warranty
Safety and Trademark
Acknowledgement
Safety
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: 1) This device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Warnings:Replacement or substitution of transistors, regular diodes or
other parts of a unique nature, with parts other than those recommended by
Cobra may cause a violation of the technical regulations of part 95 of the FCC
rules, or violation of type acceptance requirements of part 2 of the rules.
CXT225C_MANL_ENG:PR270-C_Eng 12/3/09 2:52 PM Page 16