Filter
Top Products
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Customer Assistance WarrantyIntroduction
Operation
Intro Operation Customer
Assistance
Warranty
Notice
Secondary Icons
Mode Functions
Operation
Intro Operation Customer
Assistance
Warranty
Notice
Secondary Icons
During channel scan (while receiving an incoming transmission),
you can choose from the following:
a.
Press and hold the Talk button to communicate on
that channel. Your radio will remain on that channel
and return to
Standby mode.
b. Press the Channel Up or Channel Down button to
resume scanning channels.
If you press the
Talk button while scanning, but more than
10 seconds after receiving a transmission, you will transmit
on the channel on which you last received a transmission.
This will return the radio to
Standby mode.
If you do not press any button within 10 seconds after
receiving a scanned transmission, your radio will automatically
resume scanning channels.
During channel scan (while not receiving a transmission),
you can choose from the following:
a.
Press and hold the Talk button to communicate on the
channel or channel/privacy code that was displayed before
you entered mode functions or the channel on which, during
scanning, you last received a transmission. This will then
return the radio to
Standby mode.
b. Press the Mode button to proceed to set privacy code scan
on the channel that was either displayed before you entered
mode functions or on which, during channel scanning, you
last received a transmission (see page 20 for further details).
c. Press the Lock/Enter button to return to Standby mode
on the channel/privacy code that was displayed before you
entered mode functions or the channel on which, during
scanning, you last received a transmission.
Channel Scan
•
Your microTALK
®
radio can automatically scan channels.
To scan channels:
1. Press the Mode button until the
Scan icon and the channel numbers
flash on the display.
2. Press the Channel Up or Channel Down
button to begin scanning channels.
The radio ignores specific privacy
codes while scanning channels.
The Scan icon will continue to be displayed
when scan is
on. Your radio will continue to
scan all channels and stop if an incoming
transmission is detected. Your radio will
remain on that channel for 10 seconds.
While setting channel scan, if you do not
press any buttons for 15 seconds, your radio
will automatically return to
Standby mode on
the channel or channel/privacy code displayed
before you entered mode functions.
Scanning Channels
M
ode Button
LI 7300
Channel Button
18
English
19
Nothing Comes Close to a Cobra
®