Cobra Electronics CP-2505 Telephone User Manual


 
Wall Mounting Instructions
The following steps enable installation on a new or existing telephone wall-
mounting plate or directly onto a wall. (Your Cobra
Intenna
is designed to be
used with any AT & T, GTE, local phone company or other wall-mounting
plates that can be purchased from most local electronics stores.)
Run telephone cord through cord wrap channel on bottom of base. (As shown).
Plug modular phone connector into telephone wall jack.
Align mounting studs on the plate to the holes on the bottom of the
Intenna
base; push base onto studs and slide down on the wall plate.
Attach the power adapter to the POWER connection (on the base of the
phone) and plug into a household AC power outlet.
To install directly on any wall, you’ll need to provide two screws and wall
anchors; follow these steps:
— Drill two holes 3
1
/
4
" apart and insert the wall anchors.
— Drive the screws into the anchors until the head of each screw is
protruding about 1/8" from the wall.
— Align the holes in the cordless base over the screw heads; push base
in and slide down on screws (see diagram #3).
— Plug modular phone connector into telephone wall jack; attach the
power adapter to the POWER connection (on the base of the phone)
and plug into to a household AC power outlet.
7
Mounting Studs
Modular Phone Jack
Diagram #2:
Installation on a
telephone wall-
mounting plate
Diagram #3:
Installation
directly on a wall
Modular Phone Jack
Screw Heads
2505.MANUAL.pm 11/7/97, 11:43 AM8