Filter
Top Products
3
ᕤConnect the red lead of DC power cord to an
accessory 12 volt fuse.
ᕥConnect the orange lead to a constant 12v fuse
(ie: cigarette lighter or direct to battery)
ᕦConnect the black lead to the negative side of
the automobile.This is usually the chassis. Any
convenient location with good electrical contact
(remove paint) may be used.
ᕧMount the microphone bracket on right side of
the transceiver or near it using two screws sup-
plied.When mounting in an automobile, place
the bracket under the dash so the microphone
is readily accessible.
ᕨAttach the 4-pin microphone cable to recepta-
cle on front of unit and install unit in bracket-
securely.
Mounting and
Connections
Note
Before installing the CB radio,
visually check the vehicle bat-
tery connections to determine
which battery terminal, posi-
tive or negative (positive is the
larger of the two) is grounded
to the engine block
(or chassis).
OperationInstallation
SQUELCH
VOLUME
DW
SCAN
S 1 3 5 9 +30
P .5 1 2 3 4
CB / WEATHER
CH 9 / 19
1