Filter
Top Products
Storing Telephone Numbers
a) ‘One touch’ locations
1.Make sure the telephone is plugged into the jack and lift the handset.
2.Press PROG button
3.Press one of the ‘One touch’ direct memory buttons, M1, M2 or M3.
4.Dial the telephone number you wish to store.
5.Press the PROG button again.
6.Repeat steps 2 to 5 for the remaining two ‘One touch’ locations.
7.Replace handset.
b) ‘Two touch’ locations
1.Make sure the telephone is plugged into the jack and lift the handset.
2.Press PROG button.
3.Press MEM button.
4.Press any button 0 to 9 on the keypad under which you wish to store the
telephone number.
5.Dial the telephone number you wish to store
6.Press the PROG button again
7.Repeat steps 2 to 6 for any other numbers you wish to store allocating a
different keypad number for each and then replace the handset.
Dialing Stored Telephone Numbers
a)‘One touch’ locations- Lift handset, await dial tone and press appropriate
direct memory button M1, M2 or M3. The stored number will be dialed out
automatically.
b) ‘Two touch’ locations- Lift handset, await dial tone. Press the MEM
button followed by the keypad button under which the desired number is
stored. The stored number will be dialed out automatically.
c)To dial a number partly stored number in a ‘One touch’ location (such as an
access code) with the remaining part in another location, lift the handset
and press the ‘One touch’ location button under which the 3 or 4 digit
access code is stored and then either press:
(i) The ‘One touch’ location button where the remainder of the
number is stored, or
(ii)The MEM button followed by the location button 0-9 under
which the remainder of the number is stored.
NOTE: If you wish to change a number in a memory
location, simply follow the instructions for storing a
number. Entering the new number will automatically
erase the previous number.
CS-30TManual.pm 10/19/03, 14:205