Filter
Top Products
FCC REGISTRATION INFORMATION
1. This equipment complies with Part 68 of the FCC Rules. On the back of this
equipment is a label that contains, among other information, the FCC registra
-
tion number and Ringer Equivalence Number (REN) for this equipment. If
requested, provide this information to your telephone company.
2. The registration jack USOC for the equipment is RJ11C.
3. An FCC compliant telephone cord and modular plug is provided with this
equipment. This equipment is designed to be connected to the telephone
network or premises wiring using a compatible modular jack which is Part 68
compliant. See installation instructions for details.
4. The REN is useful to determine the quantity of devices that may be connected
to the telephone line. Excessive RENs on the telephone line may result in the
devices not ringing in response to an incoming call. In most, but not all areas,
the sum of RENs of all devices shouldnot exceed five (5). To be certain of the
number of devices that may be connected to a line, as determined by the total
RENs, contact the local telephone company.
5. If your telephone equipment causes harm to the telephone network, the
telephone company will notify you in advance that tem-porary discontinuance of
service may be required. But if advance notice isn’t practical, you will be notified
as soon as possible. You will be advised of your right to file a complaint with the
FCC if you believe it is necessary.
6. Your telephone company may make changes in its facilities, equipment, opera
-
tions, or procedures that could affect the operation of your equipment. If they
do, you will be given advance notice so as to give you an opportunity to maintain
uninterrupted service.
7. If you experience trouble with this equipment, please contact Clarity Cus
-
tomer Service Department at 1-800-426-3738 for repair/warranty information.
If your equipment is causing harm to the telephone network, the telephone
company may request that you disconnect the equipment until the problem is
resolved.
8. This equipment may not be used on public coin service provided by the
telephone company.Connection to party lines is subject to state tariffs. (Contact
your state public utility
commission or corporation commission for information.)
This equipment complies with Industry Canada CS03.
The Load Number of the equipment is 20.
The standard connecting arrangement code for the equipment is CA11A.
NOTICE: The Canadian Department of Communications label identifies
certified equipment. This certification means that the equipment meets certain
telecommunications network protective operational and safety requirements.
The Department does not guarantee that the equipment will operate to the
user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to
be connected to the facilities of the local telecommunications company. The
equipment must also be installedusing an acceptable method of connection. In
some cases, the company’s inside wiring associated with a single line individual
service may be extended by means of a certified connector assembly (telephone
extension cord). The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian main
-
tenance facility designated by the supplier. Any repairs or alterations made by the
user to this equipment, or equipment malfunctions, may give the telecommunica
-
tions company cause to request the user disconnect the equipment.
Users should ensure for their own protection that the electrical ground con
-
nections of the power utility, telephone lines and internal metallic water pipe
system, if present, are connectedtogether. This precaution may be particularly
important in rural areas.
Caution: Users should not attempt to make such connections themselves, but
should contact the appropriate electric inspection authority, or electrician, as
appropriate.
The Load Number (LN) assigned to each terminal device denotes the percent
-
age of total load to be connected to a telephone loop which is used by the
device to prevent overloading. The termination on a loop may consist of any
combination of devices subject only to the requirement that the total of the load
numbers of all the devices does not exceed 100.
WARRANTY & SERVICE
The following warranty and service information applies only to products
purchased and used in the U.S. and Canada. For warranty information In other
countries, please contact your local retailer or distributor.
Limited Warranty
Clarity, a division of Plantronics, Inc. (“Clarity”) warrants to the original con-
sumer purchaserthat, except for limitations and exclusions set forth below, this
product shall be free from defects in materials and workmanship for a period of
one (1) year from the date of original purchase (“Warranty Period”). The obliga-
tion of Clarity under this warranty shall be limited to repair or replacement, at
Clarity’s option, without charge, of any part or unit that proves to be defective in
material or workmanship during the Warranty Period.
Exclusions from Warranty
This warranty applies only to defects in factory materials and factory workman-
ship. Any condition caused by accident, abuse, misuse or improper operation,
violation of instructions furnished by Clarity, destruction or alteration, improper
electrical voltages or currents, or repair or maintenance attempted by anyone
other than Clarity or an authorized service center, is not a defect covered by
this warranty. Telephone companies manufacture different types of equipment
and Clarity does not warrant that its equipment is compatible with the equip-
ment of a particular phone company.
Implied Warranties
Under state law, you may be entitled to the benefit of certain implied warranties.
These implied warranties will continue in force only during the warranty period.
Some states do allow limitations on how long an implied warranty lasts, so the
above limitation may not apply to you.
Incidental or Consequential Damages
Neither Clarity nor your retail dealer or selling distributors has any responsibil-
ity for any incidental or consequential damages including without limitation, com
-
mercial loss or profit, or for any incidental expenses, expenses, loss of time , or
inconvenience . Some states do not allow exclusion or limitation of incidental or
consequential damage, so the above limitation or exclusion may not apply to you.
Other Legal Rights
This warranty gives you specific legal rights and you may also have other rights
which vary from state to state.
How to Obtain Warranty Service
To obtain warranty service, please prepay shipment and return the unit to the
appropriate facility listed below.
In the United States:
Clarity Service Center
4289 Bonny Oaks Drive, Suite 106
Chattanooga, Tennessee 37406
Tel. (423) 622-7793 or
(800) 426-3738
Fax: (423) 622-7646 or
(800) 325-8871
In Canada:
Plantronics Service Center
8112 Trans Canada Highway
Ville Saint-Laurent
Quebec H4S 1M5
Tel: (800) 540-8363
(514) 956-8363
Fax: (514) 956-1825
Please use the original container, or pack the unit(s) in a sturdy carton with suf
-
ficient packing material to prevent damage. Include the following information:
1. A proof-of-purchase indicating model number and date of purchase.
2. Bill-to address
3. Ship-to address
4. Number and description of units shipped
5. Name and telephone number of person to call, should contact be necessary
6. Reason for return and description of the problem. Damage occurring during
shipment is deemed the responsibility of the carrier, and claims should be made
directly with the carrier.
Clarity, a Division of Plantronics, Inc.
4289 Bonny Oaks Drive
Chattanooga, TN 37406
(800) 426-3738
www.clarityproducts.com
©2005 Clarity, a Division of Plantronics, Inc. All Rights Reserved. Clarity, the
amplification device, Clarity and the amplification device combined, Amplifying
Your Life, and Clarity Power are trademarks or registered trademarks of
Plantronics, Inc.