Filter
Top Products
2-5
Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways Software Configuration Guide
OL-16191-01
Chapter 2 Configuring Your Voice Gateway Using the setup Command
Completing the Configuration
interface FastEthernet0/0
media-type 100BaseX
half-duplex
ip address 9.13.38.150 255.255.255.0
!
interface FastEthernet0/1
shutdown
no ip address
dialer-list 1 protocol ip permit
!
end
Completing the Configuration
After you have entered all the prompted information for the setup command, the system displays the
configuration.
Procedure
Step 1 The system asks if you want to save this configuration, with the following options:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you enter 0, the system does not save the configuration information that you entered, and you return
to the voice gateway enable prompt (
VG#). Enter setup to return to the system configuration dialog.
If you enter 1, the system returns you to the setup command without saving the configuration.
If you enter 2, the system saves the configuration and returns you to the user EXEC prompt
(VG>).
Step 2 When the messages stop appearing on your screen, press Return to get the VG> prompt.
Step 3 The VG> prompt indicates that you are now at the CLI and you have just completed a basic voice gateway
configuration. However, this is not a complete configuration. At this point you have two choices:
• Run the setup command again and create another configuration. Enter the following:
VG> enable
Password: password
VG# setup
• Modify the existing configuration or configure additional features with the CLI as described in
Chapter 3, “Configuring Your Voice Gateway Using the CLI.”