Data Sheet
© 2008 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 3 of 5
Voice gateway
●
Session Initiation Protocol (SIP) v2 (RFC 3261, 3262, 3263, 3264)
SIP proxy redundancy-dynamic via DNS SRV, A records
Reregistration with primary SIP proxy server
●
SIP support in Network Address Translation (NAT) networks (including Serial Tunnel
[STUN])
●
Highly secure (encrypted) calling via prestandard implementation of Secure RTP
Voice algorithms
●
Codec name assignment
●
G.711 (A-law and µ-law)
●
G.726 (16/24/32/40 kbps)
●
G.729 A
●
G.723.1 (6.3 kbps, 5.3 kbps)
●
Dynamic payload
●
Adjustable audio frames per packet
Voice specifications
●
Dual-tone multifrequency (DTMF): in-band and out-of-band (RFC 2833) (SIP info)
●
Flexible dial plan support with interdigit timers and IP dialing
●
Call progress tone generation
●
Jitter buffer-adaptive
●
Frame loss concealment
●
Full duplex audio
●
Echo cancellation (G.165/G.168)
●
Voice activity detection (VAD) with silence suppression
●
Attenuation/gain adjustments
●
Flash hook timer
●
Message waiting indicator (MWI) tones
●
Visual message waiting indicator (VMWI) via frequency shift keying (FSK)
●
Polarity control
●
Hook flash event signaling
●
Caller ID generation (name and number)-Bellcore, DTMF, European
Telecommunications Standards Institute (ETSI)
●
Music on hold client
●
Streaming audio server-up to 10 sessions
Fax capability
●
Fax tone detection pass-through
●
Fax: G.711 pass-through or real-time fax over IP via T.38 (T.38 support is dependent on
fax machine and network/transport resilience.)
Security
●
Password-protected system reset to factory default
●
Password-protected administrator and user access authority
●
Provisioning/configuration/authentication:
HTTPS with factory-installed client certificate
●
HTTP digest-encrypted authentication via MD5 (RFC 1321)
●
Up to 256-bit Advanced Encryption Standard (AES) encryption
Provisioning, administration,
and maintenance
●
Web browser administration and configuration via integral web server
●
Telephone keypad configuration with interactive voice prompts
●
Automated provisioning and upgrade via HTTPS, HTTP, Trivial File Transfer Protocol
(TFTP)
●
Asynchronous notification of upgrade availability via NOTIFY
●
Nonintrusive, in-service upgrades
●
Report generation and event logging
●
Stats in BYE message
●
Syslog and debug server records-per-line configurable
●
Per-line and purpose configurable syslog and debug options
Physical interfaces
●
Two 100BASE-T RJ-45 Ethernet ports (IEEE 802.3)
●
2 RJ-11 FXS phone ports-for analog circuit telephone device (tip/ring)
Subscriber line interface
circuit (SLIC)
●
Ring waveform: trapezoidal and sinusoidal *
●
Maximum ringer load: 3 ringer equivalence numbers (RENs)
●
On-hook/off-hook characteristics:
On-hook voltage (tip/ring): -50V nominal
Off-hook current: 25 mA min
Terminating impedance: 8 configurable settings including North America 600 ohms,
European CTR21