Filter
Top Products
6-5
Cisco Unified IP Phone 7940G/7960G Administration Guide for Cisco Unified CallManager 4.2(3)
OL-8555-02
Chapter 6 Viewing Model Information, Status, Statistics, and Security Information on the Cisco Unified IP Phone
Status Menu
Table 6-2 Status Messages on the Cisco Unified IP Phone 7940G/7960G
Message Description Possible Explanation and Action
BootP server used The phone obtained its IP
address from a BootP server
rather than a DHCP server.
None. This message is informational only.
CFG file not found The name-based and default
configuration file was not
found on the TFTP Server.
The configuration file for a phone is created
when the phone is added to the
Cisco Unified CallManager database. If the
phone has not been added to the
Cisco Unified CallManager database, the
TFTP server generates a
CFG File Not Found
response.
• Phone is not registered with
Cisco Unified CallManager.
You must manually add the phone to
Cisco Unified CallManager if you are not
allowing phones to auto-register. See the
“Methods for Adding Phones to the
Cisco Unified CallManager Database”
section on page 2-11 for details.
• If you are using DHCP, verify that the
DHCP server is pointing to the correct
TFTP server.
• If you are using static IP addresses, check
configuration of the TFTP server. See the
“Network Configuration Menu Options”
section on page 4-3 for details on
assigning a TFTP server.
CFG TFTP Size Error The configuration file is too
large for file system on the
phone.
Power cycle the phone.