Filter
Top Products
3
Troubleshooting
Intercom does not function.
Check batteries in intercom. If using a DC Adapter
ensure that it is plugged in.
Ensure intercom is connected to a network.
See Programming Intercom.
Ensure that intercoms are on the same channel.
See Operation & Features.
Intercom is not getting expected transmission
range.
Keep antenna vertical. Keep intercom away from metal
objects and electrical wiring. Cell phones, cordless
phones, or other radio devices may also limit range.
Intercom beeps every ten minutes.
The battery is low in the intercom. Replace with AA
Alkaline batteries or operate it with DC Adapter
(not provided). A 12 Volt, 300mA DC Adapter may be
used (center positive polarity on the round plug).
Static and feedback is heard in intercom.
The intercoms are too close to each other. A cordless
phone, cell phone, or other radio devices can also cause
static.
The intercom does not connect to another intercom
and a green light is on longer than 3-1/2 minutes.
The intercom is out of range. Place the intercom closer
to the other intercoms in the network, with the antenna
pointing up.
The other intercom in the network has no power.
Replace the batteries.
The intercom has not completed programming.
Clear the intercom's memory and reprogram.
Need to clear intercom’s memory.
Press and hold Learn button, an initial beep will be
heard. Continue to hold until a second beep is heard
(about 6 seconds). Ensure other intercoms are not
activated during this time. Once memory is clear the
intercom can be programmed to a new network.
Intercom is sending audio while no buttons are
pressed.
The sending intercom is set to Monitoring Mode or Voice
Activation Mode and will activate when sound is heard.
It can be taken out of Monitoring Mode by pressing the
Talk button. It can be taken out of Voice Activation Mode
by setting Dipswitch #1 to DOWN position.
See Operation & Features.
Intercom can not be programmed to network.
A network may contain up to 12 intercoms or doorbells.
It may be necessary to clear the network and reprogram
all the intercoms to the network.
See Programming Intercom.
NOTE: Manufacturer is not responsible for any radio or
TV interference caused by unauthorized modifi cations to
this equipment. Changes or modifi cations not expressly
approved by the manufacturer could void the authority
to operate the equipment.