Filter
Top Products
7
2.4 Installation of Satellite I/O Box (1 unit)
Environment Setup
1) Make sure that the POWER switch of the I/O Box is set to OFF.
2) Set the DIP switches provided on the rear panel to the following.
Table 2.1
12345678910
ON OFF OFF OFF ON OFF ON ON ON ON
Note:
The above settings assume that the communication speed is set to 115,200 bps.
To set a different baud rate modify the SW6, SW7, and SW8 settings as follows:
Table 2.2
Baud Rate SW6 SW7 SW8
9,600 bps OFF ON OFF
19,200 bps ON ON OFF
38,400 bps OFF OFF ON
57,600 bps ON OFF ON
115,200 bps OFF ON ON
Connection
1) Connect the AC adaptor to the I/O Box.
2) Connect the I/O Box to the PC with the RS-232C cross-type cable.
Start-up
1) Set the POWER switch to ON.
2) Make sure that the “READY POWER” lamp lights in green.