Filter
Top Products
43
COM2
Either the 14-pin serial I/F or IrDA 1.0 can be assigned to this COM2 port depending on the system
library setup. Both the 14-pin serial I/F and IrDA 1.0 can be used as a normal RS-232C interface. By
default, the COM2 channel is not assigned to either device. Therefore, always use the system library
to designate either the 14-pin serial I/F or IrDA, then turn on the power. The 14-pin serial I/F is
located on the rear of the panel.
Pin assignment
Pin 1. GND
Pin 2. GND
Pin 3. N.C.
Pin 4. SD
Pin 5. RD
Pin 6. RS
Pin 7. ER
Pin 8. CS
Pin 9. CI
Pin 10. DR
Pin 11. CD
Pin 12. EXTSW
Pin 13. VH
Pin 14. VH
Fig. 2.11
COM3
A modem card, if one is inserted in the PC card slot, can be used as the COM3 port.
(refer to Chapter 2.3.6 “PC Card”.)
COM4
The COM4 port is dedicated for IrDA 1.1. It is used internally by the FLINK Utility. Therefore, it
cannot be directly controlled by application programs.
8
1
9
2
10
3
11
4
12
5
13
6
14
7