Filter
Top Products
24
Using a CompactFlash Card
Your CASSIOPEIA supports Type I and Type II CompactFlash cards (3.3V).
Important
• The card slot cover will not close when certain types of cards are in the slot. Remove
the card slot cover and keep it in a safe place so you can replace it when you remove
the card.
• Gently but firmly slide the card into place as far as it will go, but do not force it.
Forcing a card can damage connectors. If you have problems inserting a card, pull it
out and check to make sure it is oriented correctly.
• We strongly recommend that you store all unsaved data you are inputting or editing
before performing this procedure.
• Sometimes, your CASSIOPEIA may not be able to detect a CompactFlash card. This
is indicated when a program on the card does not start up normally. When this
happens, remove the card, reinsert it, and then press the CASSIOPEIA RESET
button.
• Your CASSIOPEIA supports 3.3V CompactFlash cards only. Cards that can operate
on 5.0V only are not supported.
• Use of an IO card that requires large amounts of power can cause the CASSIOPEIA
to restart when CASSIOPEIA battery power is low.
1.Make sure your CASSIOPEIA is turned off.
• Press the [Power] button to turn off power.
2.Pressing upward at the point indicated in the illustration, slide the cover up to open it.
3.If there is already a card in the slot, remove it.
Important
Pull the cover out as far as it will
go and then swing it open.
Press upward here.