Filter
Top Products
8
| SCALA RIDER
®
Q2
™
MultiSet
4. Use the pre-moistened Towelette to clean the helmet
area where you want to install the Glue Plate. Allow to dry
thoroughly.
5. Peel the foil cover from the Glue Plates’ adhesive pad.
6. Place the Glue Plate into position according to #3. Press rmly 15
seconds on all 3 parts of the Glue Plate.
7. The adhesive pad bonds to full strength over the next 24 hours.
Therefore it is recommended to not use the headset during this 24
hour period.
8. Fasten the Clamp to the Glue Plate using the Allen screws that were
previously removed.
POSITIONING THE SPEAKERS
Attach the speakers to the Velcro
inside your helmet opposite your ears
(short speaker cord for the left ear [A]
and the long speaker cord [B] for the
right ear). You may want to use the
supplied Velcro pad.
Using two speakers inside the helmet may be prohibited in
certain jurisdictions. If this is the
case, you should tuck away the
long corded speaker underneath
the helmet padding as follows:
Lead the speaker [B] alongside the
rim of the padding to the right
side and then back to the left
side, near speaker [A]. Then place the
speaker [B] underneath the padding.
ATTACHING AND REMOVING THE
HEADSET FROM THE HELMET CLAMP
ATTACHING:
Slide the headset downwards along
the sliding panel until a clicking
sound indicates that the headset is
locked in place.
REMOVING:
Your headset can be removed for
charging and storage by pressing
your finger gently against the tab
and sliding the headset up with the
other hand.
We recommend that you remove the
headset from the helmet when not in use.
Press here to remove
Speaker A
Speaker B
Speaker B
Cable
Speaker A
Speaker B