Filter
Top Products
General Information
4
1
Note
• If you hear three short beeps, the cordless
handset did not register. Repeat steps b
and d.
• If you want to install another cordless
handset, repeat steps a through d.
e Press Stop/Exit on the control panel of
the machine (base unit).
For Color LCD models (base unit)
1
a Press Menu/OK on the cordless
handset.
Note
If you see Enter Register HS Mode
on Base Unit on the LCD of the
cordless handset, go to step c.
b Press a or b to choose Register HS.
Press Menu/OK.
c Press Menu on the control panel of the
machine (base unit).
d Press a or b to choose
Initial Setup.
Press OK.
e Press a or b to choose
Register Handset.
Press OK.
f Press a or b to choose Register.
Press OK.
You will hear one long beep when the
cordless handset is registered correctly.
Note
• If you hear three short beeps, the cordless
handset did not register. Repeat step b
and f.
• If you want to install another cordless
handset, repeat steps a through f.
g Press Stop/Exit on the control panel of
the machine (base unit).
Deregistering cordless
handsets
If you want to register a handset that has
already been registered, with another
machine (base unit), you should deregister it
first, and then register it with the other
machine (base unit). (See Registering
additional cordless handsets on page 3.) If
you are using more than one cordless
handset, deregistration will remove all
handsets registered with the machine (base
unit).
Note
Do not operate any other cordless
handsets until deregistration of the
cordless handset you are removing has
completed.
For non-Color LCD models (base unit) 1
a Press Menu, 0, 6 on the control panel of
the machine (base unit).
b Press Erase.
Then, confirm the Delete by pressing 1.
c Press Stop/Exit.
For Color LCD models (base unit)
1
a Press Menu on the control panel of the
machine (base unit).
b Press a or b to choose
Initial Setup.
Press OK.
c Press a or b to choose
Register Handset.
Press OK.
d Press a or b to choose Terminate.
Press OK.
Then, confirm the Delete by pressing 1.
e Press Stop/Exit.