Filter
Top Products
Owners label.
You can write your phone number(s) on
the card under the handset. Remove the
plastic cover with a pencil or similar.
Using the loudspeaker
for handsfree operation
The loudspeaker enables handsfree
operation – where you can make and receive
calls without picking up the handset. You
hear the caller through the built in speaker.
Adjust the loudspeaker volume by sliding
the switch on the right hand side of the base.
Press the HANDSFREE button.
The Speaker light and Line 1 light
both come on.
Adjust the VOLUME switch and
listen for the dial tone.
DIAL Dial the number your require.
To end the call, press the
HANDSFREE button. The Speaker
and Line 1 lights go out.
H
a
n
d
s
f
r
e
e
H
a
n
d
s
f
r
e
e
Press buttons in order shown
Your Converse 2-Line will hold
the last number dialled – up to 31
digits – in its memory.
Lift the handset or press the
HANDSFREE button (to dial on
Line 2, press and release the
LINE 2 button while you do this).
Press the REDIAL button.
You can use your Converse 2-Line
as an alarm clock. The display
gives you 15 seconds to complete
each setting. If you do not press
any button in that time, the display
returns to normal and you must
start again from the beginning.
Press the FUNCTION button
three times. Display shows the
current alarm setting.
Press
1 to select AM or 2 to
select PM.
Use the keypad to enter the time
at which you want the alarm to go
off, e.g.: 0500 = 5-o-clock.
Press the
SHIFT button to switch
the alarm on and off. The display
will only show when the alarm is
switched on.
S
h
i
f
t
2
A
B
C
1
F
u
n
c
t
i
o
n
R
e
d
i
a
l
L
i
n
e
2
H
a
n
d
s
f
r
e
e
9
To make a handsfree call on
Line 1
To redial the last number called
To switch the alarm on and off
Please note once the alarm is set
it will come on daily, unless you
switch it off manually by resetting
the alarm.